Length varies in chamber?

[StanWest]

Hello the Forum, Thanks to this forum, I have learned a lot. My Urologist thanks me for in informing him at times
>>>>>>>>>>>----Introductory Info-----------<<<<<<<<<<<<<<<
My ED began perhaps 2 ~ 2 1/2 years ago. I became totally flaccid. Found my testosterone level below (1/2 of) lowest normal. Age 68 then. Started using a home made pump. Lab grade vacuum pump, hospital grade regulator with built in gage. Cheaper blue plastic chamber. Only the chamber causing problems sucking in balls (ouch).

At first pump did NOTHING. 1 inch flaccid. Viagra or tadafil nada. From forum, continued pumping (continues). After ten uses started bring life back to cock. Now close to original length 6" (sometimes). Not great, not tiny, and sure precious to me. Just to have it in good health. I also have venous leakage. I read about fill and release, fill and release. Great. Oh yes, great. I have had to inject last 1 1/2 years trimix. Now have had intercourse 3 times with using the ring along. Not as firm as with trimix and ring together, but very nice, firm enough I don't get the SLINKY effect. By that I mean a compression in lengthening in then expanding, the pulling a springy cock out (stretching in length as I pull outward) then returning to nominal size. This is from about 1 month of fill then drain pumping.
>>>>>>>>>>>----- My Pumping---------<<<<<<<<<<<<<<<
Pumping has restored my erect length. Not looking to change size, just bring back my normal size. Many times when I fill the erect length varies (next section). Then after 30 seconds begins a period of slow stretch increasing PERHAPS another 1/2" (varies some) After this first stretch in a set of fills and releases this secondary stretching is much less. Like the tissues remembers this stretching!
What ever I fill to, it reachs a length in 10 seconds max. 4 seconds typical. The max pressure is use is 170 mm Hg, comes out to about 3.3 psi. A hole I drilled in the chamber when not covered by my finger leaks air, the pressure is around 2.2 psi. 3.3 psi stings a little during first 30 seconds then is no problem nor pain with 3.3 psi.
>>>>>>>>>>>-----Length Varies---------<<<<<<<<<<<<<<<
Many episodes I will initially fill to 4", 4 1/2, 5, 3 1/2" ...... Not consistent. And then I can stretch slowly. Pulling chamber off enough, deflate then fill I can get. It can stretch to a different length, taller or shorter?? If I remove the chamber use a ruler to measure, manually I stretch to 6". I have filled to 6" on occasion. At times I thought this was from placing the chamber on differently. Maybe it is. If placed wrong I get my balls sucked in. Ouch! Don't like that at all. I am looking for a smaller diameter chamber currently (because of ball sucked in). I am using a good quality pressure regulator / gage, in fact it is the same model that was in my hospital room 8 months ago during surgery. The inside ID is 2 1/4". I would do well with <= 1.5" ID.

Anybody else have this experience?

[bldoink]

I got a little confused but if I understood correctly then it sounds about right.