FrankTalk.org

Interested in this product. How does the ring loading applicator work?

Ralphi,

It is kind of a cool product.

It has two pieces. The Loading Cone and the Loading Ring.

The Ring has a flush edge and a raised ridged edge.

The Ring fits onto the Cone with the flush edge against the cone.

Put a little astroglide type lube on the cone and ring surface.

With the Ring + Cone on a flat surface press the cock ring down over the cone all the way onto the ring.

Remove the loaded loading ring.

Slide the load ring+cockring down over your member (with the flush edge pointing towards you).

When in position just slip off the cockring and remove the loading ring.

(The load ring inner diameter can easily fit a 6+ inch girth so shld fit most any erection).

Maybe I can do up a few pictures if you are a Visual Learner ...

J

Thanks. Pictures would be great!

Here is the loadring, the loader and an Osbon Ring.
The loadring is about 2" inner diameter.

Here are the three items assembled and ready to load.

Press down firmly with as many fingers as you can.
Astroglide or other lube helps (but also watch out you don't shoot the band across the room and lose it).

OK now position with flush edge toward you (so's you can slip it off).

SLide on down as far as you can.

Finally remove the loadring and you are done.
(You could do two rings at once also -- usually that's how many you would need for good holding power).

Thanks. Now I get it. Put in order today.

Do you prefer the Osbon rings to the ones that come with the Encore? If so, why?