Page 1 of 1
Just bought osbon tension ring, question?
Posted: Sat Nov 08, 2014 9:33 am
by mlc2010
I presumed this was a cockring allowing me to keep pge1 in unit, however it seems impossible to get on, have I bought the right thing? Its medium standard tension, pressure point ring
would it better if I bought the constriction loop?
Re: Just bought osbon tension ring, question?
Posted: Mon Nov 10, 2014 11:22 pm
by JimStars
Mlc,
Which one did you get? And yeah they are not meant to be put on directly. They need to be slipped onto a tube and then slipped off onto your member. Any old tube will do tho -- as long as you sand all the edges smooth. Then you will have to practice loading it without it SLINGING itselfd across the room behind some furniture never to be found until your mother-in-law shows up for Thanksgiving...
J
Re: Just bought osbon tension ring, question?
Posted: Tue Nov 11, 2014 9:42 am
by dtwarren1942
I do not believe the Osbon is meant to be used to hold in the PGE1 in. If you inject the proper dose, you should be able to get a decent erection on its own. However, if you do not get a sufficient erection, the Osbon can be used to improve the erection.
Jim is correct in advising that a tube can make the process easier; however, I quite often slip mine on without the aid of a tube. The Osbon is very strong and can be stretched enough with two fingers of each hand to fit over your erection and slid down to the base. Make sure your erection is well lubed. May take some practice though.
Re: Just bought osbon tension ring, question?
Posted: Wed Nov 12, 2014 8:12 am
by terraplane
I have been using these rings
http://www.amazon.com/gp/product/B005VJ ... UTF8&psc=1 I started by just putting one at the base , now I put one under the glans also , and leave them on until I get hard , seems to hold the Trimix in a lot better , usually takes 5 to 10 minutes ............Chuck
Re: Just bought osbon tension ring, question?
Posted: Thu Nov 27, 2014 7:38 pm
by yegbert
I use the ones like Chuck referenced with some manual kegeling to get myself at least a little chubby before injecting Caverject (alprostadil), primarily to give me a somewhat bigger target before injecting, but I guess it also helps to keep the meds in too. I've used the Osbon rings but only after pumping with a VED to keep the erection that I get from the pumping. I too believe the Osbon rings would be too difficult to get on without a tube similar to the type used with VEDs.
Re: Just bought osbon tension ring, question?
Posted: Thu Nov 27, 2014 9:52 pm
by dtwarren1942
The Osbon bands are extremely durable and can be stretched hard enough to fit over an erect shaft. However, the shaft needs to be lubricated and the bands need to be stretched with fingers inside the main opening, not the "ears."