formula potency versus volume

[sommers]

Fairly new to Trimix and still working on arriving at my optimal dose
However, am wondering the trade offs between the volume of the solution versus it's potency. For example--if you had a sub optimal dose -- could you increase it's effect/potency by simply injection a larger volume?
and vice versa--if you had too strong a dose--could you modify it by injecting a lower volume?
thanks!

[bldoink]

I'm not a medical professional of any kind. Anything I post is based on my own experiences, at best and hallucinations or delusions at worst. Any advice found on an internet forum is likely worth what you paid for it, or worse. Always ask your doctor and follow his/her advice.

Ultimately the effectiveness should be based on the amount of the actual drugs or chemicals delivered and not on the volume of the carrier, be it saline, bacteriostatic water, or whatever. In my experience the overall volume can effect the comfort level. A lower volume carrying the same amount of the drug can sometimes cause some discomfort as it shocks the tissues more than a larger more diluted mix. I speculate that the larger volume version may require less massaging in of the injection. I use a very strong mix that hurts if injected too fast. I get along by depressing the plunger in many small pulses over a longer time. My experience has shown that the same amount of the drugs in a larger volume of the carrier doesn't hurt when injected faster.

[sommers]

I guess I posed my question wrong (or maybe I don't understand this at all) . Here's another try

Let's say you have a mix at a certain potency of the 3 ingredients (Trimix) and it's in a certain volume

Would increasing the volume of that mix--increase it's effectiveness? (your reply seems to indicate it would not)

[bldoink]

Yes, more of the same juice normally has a greater effect. Assuming your question is as simple as it seems.

[Stutz427]

Yes you can. My Dr. started me outwith a low dose low volume and asked me to increase the injections by 5 units each time until I got the results I wanted. Well went through the first vial and at the end was injecting 35 units with minimal results. Same with the second vial of a stronger dose. Am just starting the third vial and will again do 5 units and keep on increasing the dose until I get to an optimal level. For me I want to inject the minimal amount. Its cheaper that way and seems to leave more room to increase things. Besides the more volume seems to be more difficult to inject. At some point I suppose one does find the correct level but it can be a lot of trial and error

[GoodWood]

My trimix is 30mgpapavarine, 4mg phentolamine, 40mcg PGE1 per milliliter (I believe it’s per milliliter)

If I take double the volume I’m getting double the active ingredients.