Dosage VS Results Question

[flatbush1]

I am a newbie to injecting and am totally confused. I am using Bimix with an auto injector.
Injection 1- used 0.12ML and got 80-85% erection
injection 2- used 0.15ML and got 75-80% ( went for a home run, didn't happen )
injection 3- used 0.18ML and got 65-75%
injection 4- used 0.20ML and got 75-80%
injection 5- used 0.2 ML and got 60-70% ( bummer )
injection 6- Used0.22ML and got 60-65% ( bigger bummer )
injection 7- used 0.26ML and got 75-80% but experienced some pain the next day but not in the injection site?? More toward the tip.
Have had no problems with erections lasting too long, have not had a 90-100% yet so one wouldn't expect it to be a problem.

I am at twice the amount I started with and am getting less of a result. So far, the amount of the injection has had little to do with the results. Anyone else have a similar experience? Did it ever level out? Any ideas? I'm lost.

flatbush1

[tomas1]

I was started with a very weak formula and ended up using 40 units to get a useable erection. I got a much stronger formula and it's much better with less of an injection.
I wouldn't worry too much about the variations of the dosages and their results. Keep going up, maybe in larger steps til you get good results.

[JimStars]

Flat,

Sounds to me like you should just stay with .12 ml then!

Often some ideal amount of Bi (or Tri) will either give you a 100% er or it will give you something less and no amount of extra will push it to 100% ... your plumbiung and hydraulics will dictate which type you are. If you are a 100% er then extra injection amount will just keep it up there longer and maybe get over 100% or end up with 4 hrs erection. If you are a less than 100% er then you just get whatever noodle you get up to and extra formula will just keep it there for 1 2 3 or whatever hours.

Also with Bimix they USUALLY just use 30mg PAP and 1mg phent .. sometimes 2 mg phent. The thing is you can hardly dissolve more than the 30mg into 1 ml of water so that is why 30 mg is tops.

What was the strength of the BiMix you have then??

J

[flatbush1]

Thanks for the replies, my bi-mix formula is 30mg/ml papaverine, 1mg/ml phentolamine. Might have to move up and try tri-mix. I had a similar experience with Muse, higher doses did less. Jimstars you may be right, backing up to the original dosage or even less may be the answer.
Thanks again.

Flatbush