getting all the trimix out of vial

Sticking a needle Where? Courage, guidance and help.
rode2nowhere
Posts: 100
Joined: Wed Dec 19, 2012 9:13 am

getting all the trimix out of vial

Postby rode2nowhere » Fri Jan 19, 2018 7:55 am

How do you get all the trimix out of a vial when it gets really low, ???

FreddyFree
Posts: 587
Joined: Mon Nov 06, 2017 12:43 pm

Re: getting all the trimix out of vial

Postby FreddyFree » Fri Jan 19, 2018 8:37 am

Withdraw the needle a bit. You will never get all of it, but most.
AMS 700 CX 18cm. x 12mm. With 3cm. RTEs. 10/10/18

old but young
Posts: 9
Joined: Sun Dec 31, 2017 2:06 pm
Location: Alabama

Re: getting all the trimix out of vial

Postby old but young » Fri Jan 19, 2018 10:48 am

Not to be considered as a recommendation, but just the way I did it.
1. Thoroughly clean the entire vial top with alcohol -- even dip it in alcohol.
2. With pliers remove the aluminum band around the seal. (Just crimping a small section should allow removal by hand.)
3. Lift the seal and draw solution from the bottom.
Testosterone, pump, rings, tadalafil 10 - 15 yrs, Trimix newbie :P

rode2nowhere
Posts: 100
Joined: Wed Dec 19, 2012 9:13 am

Re: getting all the trimix out of vial

Postby rode2nowhere » Fri Jan 19, 2018 11:05 am

thanks

FreddyFree
Posts: 587
Joined: Mon Nov 06, 2017 12:43 pm

Re: getting all the trimix out of vial

Postby FreddyFree » Fri Jan 19, 2018 11:36 am

old but young wrote:Not to be considered as a recommendation, but just the way I did it.
1. Thoroughly clean the entire vial top with alcohol -- even dip it in alcohol.
2. With pliers remove the aluminum band around the seal. (Just crimping a small section should allow removal by hand.)
3. Lift the seal and draw solution from the bottom.


Thanks oxymoron. ;)

Interesting, I may try this. However it will only save a few cents. I think the pliers need to be sterilized as well.
AMS 700 CX 18cm. x 12mm. With 3cm. RTEs. 10/10/18

User avatar
happycamper59
Posts: 191
Joined: Tue Aug 01, 2017 11:02 pm

Re: getting all the trimix out of vial

Postby happycamper59 » Fri Jan 19, 2018 1:11 pm

I was wondering the same thing. I did ask the pharmacist and he pretty much said what you said, to pry it off carefully, but make sure you have a sterile environment and don't break the glass vial!

It's a one-time thing, as the vial will not be used again. I'm going to try it next time, as I may not have a full injection amount in the last vial. I have my refills, so it could get tricky. It's still fairly expensive as I use 60 units (0.6 ml).
ED worsened over 25 years, likely VL. Went through pills and injections, and results faded over time. Implant AMS 700CX, 21 cm, no RTE, on 6/3/24.

User avatar
bldoink
Posts: 3918
Joined: Mon Apr 03, 2017 12:58 am
Location: Fl.

Re: getting all the trimix out of vial

Postby bldoink » Fri Jan 19, 2018 3:28 pm

My heritage is mostly Scottish and my coin pure squeaks loudly from lack of use but even I'm not going to be prying off the rim to get the last partial drop of meds.
R.R.P 2011 Mayo Jacksonville, Dr. M. Wehle. Not nerve sparing. C in margins. Radiation 2023, V.E.D, Viagra and PGE-1 (80mcg/ml) injections @ 8 - 14 units. Originally Edex20, then compounded PGE due to cost. Inject. 12 yrs. It works. Treasure coast of FL.

Tsanchez12369
Posts: 227
Joined: Fri Dec 23, 2016 7:52 pm
Location: SAN Francisco

Re: getting all the trimix out of vial

Postby Tsanchez12369 » Fri Jan 19, 2018 8:12 pm

I get everything out by adding air and then slowly withdrawing needle while filling the needle.
Sept 11, 2018: excision, grafting (human cadever tissue) and implant. Doc is Dr Edward Karpman in Mountain View, surgery at El Camino Hospital, LOS Gatos CA. AMS 700 CX infrapubic 18 cm + 3 cm RTE. http://www.peyroniesforum.net/index.php

Cigar56
Posts: 684
Joined: Fri Aug 15, 2014 10:56 am

Re: getting all the trimix out of vial

Postby Cigar56 » Sat Jan 20, 2018 9:51 am

Hahaha, no offense. Some of these posts remind me of my sister-in-law, who splits open the "empty" tube of toothpaste to get another couple brushes. She is notoriously frugal, so much so that when dining out she and her husband will order just one meal and split it.

On the other hand, they are retired school teachers, and probably have $2 million in savings and assets because of their frugality and a lifetime of successful investing off of school teacher salaries.

So, I salute you guys draining those trimix bottles to the last drop!
I've tried everything -- pills, injections pumps -- and now I am at the final frontier.

Larry10625

Re: getting all the trimix out of vial

Postby Larry10625 » Sat Jan 20, 2018 10:59 am

old but young wrote:Not to be considered as a recommendation, but just the way I did it.
1. Thoroughly clean the entire vial top with alcohol -- even dip it in alcohol.
2. With pliers remove the aluminum band around the seal. (Just crimping a small section should allow removal by hand.)
3. Lift the seal and draw solution from the bottom.



Yup, that'll do it :D

Larry


Return to “Injections”

Who is online

Users browsing this forum: No registered users and 145 guests