Injections questions

[Cigar56]

I have injected 4 times and 2 have worked hence the 50%.

OK, I get it. Stay with it. As you perfect your technique you should see your success rate get to 95 percent plus.

[Christopher1]

Be careful. These trimix injections can cause Peyronies Disease. It happened to me.

[Christopher1]

Be careful. These trimix injections can cause Peyronies Disease. It happened to me.

[Tallboy57]

Thanks for the good advice.

[Hunchback]

Hello Tallboy,

I am planning to make a HD video with instructions but it'll take a while.
In the mean time, a couple of tips i can give you, after 10-11 years of use (keep in mind, these are just pointers and ofc things will vary between users):

* You should always pull your foreskin back, if you have any. The two reasons for that are that one you should never inject in the glans and two having the glans exposed allows you to properly position your penis (see later points)

* You should keep your penis straight, in therms of circular motion around it's "core" or lenght ax. Meaning, it should not be twisted around.

* I have found that injecting closer to the glans has better results, compared to closer to the base.

* Keep the needle at a 90 degrees angle to the shaft, pointing at it's center.

* Always change side for each injection, left and right as well relative distance from the base to the glans. This allows to avoid scar tissue that might form during the years.

* A technique that i just recently discovered and it seems to work very well so far, it sounds complicated but it's actually very simple - Hold the penis in one hand between your fingers and pull it slightly towards it's tip and then gently squeeze it vertically, meaning squeezing at the "back" and "belly", not "left" and "right". What this does is flatten slightly the corpus carvenosa, effectively giving them more surface if you then inject perpendicularly from the left or right.

* Lastly, if you, like me, are afraid of needles, know that the stress can cause additional problems with the medication, it can block completely healthy people so... If you can try to have your partner do the injection for you. If you trust him/her, it will go smoother and you'll be at an easier mind.


P.S. It's perfectly normal for the medication not to work every time, as you can see from my own thread i started here a couple of days ago. It's quite unpleasant and a "turn down", but there's nothing you can do about it really, other than try again later...

[JimStars]

Tall,

As I mentioned in another thread not long ago, I have had well over 1000 shots and never had a failure.

I did not think this was unusual, but it seems like it might be and whatever I am doing must be a good idea.

Your comment about loose skin is the first clue. Best to plump up as much as you can get -- when I do it is almost like a big firm soft-on -- no loose skin. How you plump up is up to you ... I do a pull and stretch from glans with left hand and squeeze base with right hand. Repeat for a minute or two until you are really plumped up. Plumping up lets you see what you are doing and gives a bigger surface target.

Then I do not stretch out straight, but position shaft on leg either left or right and gently hold it there by the glans with left hand and always use the right hand to inject -- after inspecting for a non-vein spot. I DIG it in I do not inject needle in one poke. Just the way I do it.

For me I will almost always see a tiny bit of blood enter the syringe which verifies it is in the right spot -- i never suck in more blood -- not needed.

When injected I do some more stretch at glans and squeeze gently from the base again and maybe waggle a few times -- repeating that will harden up in a couple of minutes no matter what. I do not massage as you would for masturbating .. just the three things.

So there ya go ...

J

[alan46]

Do you always get rock hard with injections?

[Tallboy57]

Please no not rock hard but firm the last 2 times I hit the the pea vein blead for a bit but not aweful the next time I got 2/3 hard but not rock hard I am heading a auto Jeff 2 with easy touch needles not sure I am setting the depth correct I am using the setting for a BD. What setting should I use and which sleeve should I use?

[fordman44]

I am heading a auto Jeff 2 with easy touch needles not sure I am setting the depth correct I am using the setting for a BD. What setting should I use and which sleeve should I use?

Your Autoject 2 should have an instruction sheet showing how to set it for your syringe. I use a BD 28 guage 1/2" needle with my Autoject EL and have the needle depth set at 5/16" and it works great.

[Tallboy57]

I do but it does not show the easy touch brand on the sheet .