Page 1 of 1

Cock and Ball ring and injecting

Posted: Sun Dec 22, 2019 7:58 am
by mikehard
I know this is an old subject and lots have been told, but I have a few questions. I like to use a single 2 inch ring around my balls and cock, get a better hard on and defiantly use less Timix when using a ring. At present use a rubber ring that does allow some movement for me to get my balls and cock out of the ring after sex. I would like to get a stainless steel ring, but my question is, with a hard on for about 2 hours how would you guys get out of it :?: or do you all have to wait until your cock gets flaccid. Then the question is how safe is this practice.

Are there any other guys that have the same results of using less Timix if they use a ball and cock ring.

Re: Cock and Ball ring and injecting

Posted: Sun Dec 22, 2019 8:54 am
by bldoink
I absolutely have the same results wearing rings. That's why I wear one. I do have a couple of metal rings. The first is a solid ring but I don't use it because it is an issue getting it off and if put on after injecting it has to be done very quickly. The other metal ring that can be removed as it is a two piece design I just don't like. I guess I'm just a silicone ring guy.

Re: Cock and Ball ring and injecting

Posted: Sun Dec 22, 2019 1:20 pm
by SteveSW
I have worn cock rings for years and often use them when injecting. This is simply my opinion, and your results may vary, but I wouldn't advise a metal cock ring that you can't get out of. From experience, I know a solid metal ring will become increasingly uncomfortable, even painful as your boner rages on well beyond when you are done using it. An erection which lasts 2 to 3 hours from an injection, might possibly last much, much longer wearing a ring you can't get off. I use rings which are a stretchy silicone or rubber blend. You can grab it, stretch it out and pull it off over your cock and balls. Again, just my opinion.

Re: Cock and Ball ring and injecting

Posted: Mon Dec 23, 2019 1:31 am
by mikehard
Thanks guys for feedback, you can never be to careful, can't picture going to ER and them using a bolt cutter to get if off :o .

Re: Cock and Ball ring and injecting

Posted: Mon Dec 23, 2019 6:54 pm
by flyingduck2019
I have a question for all the cock ring users out there: Can I proceed this way, put on the rubber cock ring before I inject. Inject and get into foreplay then actual intercourse. After finishing sex remove the cock ring. OR, would it be better to inject, put on ring, foreplay, sex and then remove ring? Any suggestions, or what seems to work best for you will be appreciated.

Re: Cock and Ball ring and injecting

Posted: Mon Dec 23, 2019 7:28 pm
by bldoink
I inject and then put on the rings. I've tried both ways but prefer the injection first but then I don't waste too much time putting the rings on because when fully developed putting the rings on would be more difficult. Try it both ways and go with whatever you like best.