FrankTalk.org

Last night I got a loaded syringe out of the fridge in prep for sex with my wife. When I was ready to inject I inserted the needle at the proper location into my cock. When I pushed on the plunger it would not move. I thought I had hit something so I pulled it out and re-inserted at another spot. Same results, plunger would not go down. I removed the needle and eye balled it and everything looked OK. When I pushed on the plunger it would move very little and nothing was coming out of the needle. I pulled back on the plunger and created a vaccum inside the syringe which returned the plunger to original spot when released. The needle had to be blocked for some reason. I discarded the entire syringe and got another one which worked just fine.

Has anyone else had this happen to them? The syringe and needle had to be good when it was loaded.

Hi Duck,

Yes it actually happened at the Dr's office while learning to auto inject. He stated that the mix had crystallized, thus the blockage. Now i always put a little extra in and after taking it out of the frig (pre-mixed) ill give the plunger a little push and shot some out. Works every time

Best
Silver

I occasionally run into a difficult plunger. I don't remove the needle from my dick but just pull pack on the plunger a tad (aspirate) and then push. That usually works. I think it's usually just an uncooperative rubber stopper on the plunger.

Thanks guys for the input. I was just curious if anyone else has had the same issue. I just tossed the whole thing and grabbed another out of the fridge. If it happens again though I think I will stop pre-filling my needles and just load one when I want to inject. I hate to waste even the low dose I need.