FrankTalk.org

Because of pain, I'm switching from Trimix (30/1/10) to Bimix (30/1). I needed 6 units of Trimix to get a very strong erection for at least a couple of hours (nerve damage from bladder removal is my problem).

Does anyone know how much Bimix I might need to get the same result? I just tried 8 units (a little more than the 6 for Trimix) and my erection was about 4/10. Disappointing!

Does this sound about like what I should expect though? Any idea about how high I might have to go? I always think that maybe I've done the injection wrong and can't trust the result.

I am thinking of increasing dose by 2 units at a time but that could take a while depending on how far I might have to go.

Thanks!

Wow... I wish! 6 units is next to nothing. I don't even have a diagnosis for my ED, let alone any surgery down there and I use 50 units of TRIPLE P SUPERMIX with 2% LIDOCAINE
Papaverine 30mg/ml - Phentalomine 2mg/ml - PGE1 50mcg/ml. That's right, 5x your Trimix PGE mcg's and also 8x the volume injected!

Lots of room to grow, so to speak. LOL

You are in the right track. You know your body better than anyone else. Going up by 2 units is a 25% increase and that seems reasonable.

Take your time. And enjoy the experiments.

As suggested, your dosage is low. I'm using a bimix that has atropine in it as well, this can increase efficiency.

Thanks everybody for your helpful posts. Just wanted to check back in with my results:

It turns out that, after switching from 6 units of Trimix, about 18 units of Bimix gets me hard (9/10) and lasts a couple of hours. I am not nearly as hard / long as I was with the Bimix, but my wife says it is actually more comfortable for her. So all good...

Thanks again.

Keep in mind that Papaverine is known to scar the penis, and you are now injecting a much higher amount of Papaverine than before. Pay attention if you start to notice changes like scar/placque developing