FrankTalk.org

I've had this happen to me in the past (it just happened again today), and I'm fairly confident that it just means I'm not using enough trimix, but I'm curious if anyone else has experienced this.

I'll inject trimix and the side I injected on will swell up and get fluffed up while the other won't swell up as much making my penis bend away from the side I injected on (I do not have peyronie's). This seems to subside when the medications subside. When this happens I won't get a hard involuntary erection, but it does make it a little easier to maintain once aroused.

Either I haven't injected enough medication, or it missed, but more often when I miss I won't get any effect at all. What I don't understand is why doesn't the medication distribute evenly across the two corporal bodies?

...

bldoink wrote:I believe your reasoning is correct. You either didn't inject enough or missed with part of the dose, with the same result. I have had that happen a couple of times.

Is it because you got the incorrect dosage or missed it? Before when I was injecting (just getting back into it after not doing injections for almost 2 years) it would either work almost too well or not at all. Like I go up 4 units and finally hit the sweet spot and end up with a 3.5 hour erection that starts to get a little worrisome other times I would get zero effect. The swelling I think is actually making it into the corporal bodies but just not enough. Though I did get a little bleeding and bruise from this one so I don't know.

...

Partial miss is possible. I use an autoinjector which pushes in the medication itself.

How many units do you use? I know it varies greatly per person, but just curious. Before when I got semi consistent results I was using 14-16 units of 20MCG/30MG/2MG. I think that's double strength trimix?