FrankTalk.org

So I put the cock ring on as flaccid, standing, plumped him up a bit manually and injected right at the outer edge of the ring, head side. I was hoping, wondering, praying (LOL) that maybe, just MAYBE the cock ring could stop the Trimix from going right back inside of me and stay in my penis. I massaged him for 5 minutes and things were happening, he was increasingly getting fuller and hardening. After 10 minutes of massaging he was 90% hard, took the ring OFF and 100% at 15 minutes!!!

He stayed at 100% for 20 minutes, occasional fluffing and then down to 70% after 30 minutes, no fluffing. Some fluffing and he could go to 80%, after 45 minutes and he was dead without the ring, so I put him on and could get to 75% for another 10 minutes.

Does anyone else do this, cock ring ON for 10 minutes, starting BEFORE injection and flaccid? I never read that.

In bullet points, best erection in 6 months:

Standing
Cock Ring
Fluffed a bit and injected away from ring towards head, 2" from base.
100% hard, massaging for 15 minutes
Stayed standing, occasional fluffing.
Could have good if not great sex with this if wife wasn't at work.

I inject first then put the ring on pretty quickly. I then leave it on. It's not so tight that I get no blood flow so I'm not time limited. It does help a good bit and allows a smaller dose of juice. In many ways similar to your routine.

When I used Trimix I would inject first, massage it for a bit to get some stiffness going then placed the ring on. It really seemed to help maintain my erection longer. Caution is don't keep it on too long. Left mine on for close to 30 minutes once and did I ache the next day. 10-15 minutes was my norm.

Interesting fellahs, your way is the exact opposite of the first part, to using a ring technique. Maybe we have a different kind of leakage and/or fill-up. I presume I can fill-up fairly well but the blood and Trimix flows back into my body, very quickly. The ring pre-injection appears to limit the backflow for me. Just throwing the idea out there, can't think of any other reason besides perfectly hitting a tiny sweet spot for me? I'll ask Uro.

I put the ring on before I inject. I leave it on after I get hard.

Alanoc8 wrote:I put the ring on before I inject. I leave it on after I get hard.

So it doesn't come off after injection at any point to going hard? You put it on flaccid and it stays on until sex is over.

Alanoc8

I see you use a Xialla ring and with great success.I am always interested in trying new kinds of cock rings.
How did you arrive at using this particular ring?

i do something similar but i don’t use a ring. i pull the head of my penis and inject about an inch from the base and 3 or 10. i use 31 gauge needle and push in to where the stub of the needle makes a little indentation. i then push in the plunger.

after i take the alcohol swab and do an “O” with my fingers around the alcohol pad to create a type of ring with my fingers. with the other hand i massage up and down the shaft. after a couple of minutes i let go and massage down try to get some into the inner part of the penis to avoid wobbling.

Phil65 wrote:

Alanoc8 wrote:I put the ring on before I inject. I leave it on after I get hard.

So it doesn't come off after injection at any point to going hard? You put it on flaccid and it stays on until sex is over.

That's right. I put it on soft and keep it on until sex is over.

AnotherOldMan wrote:

Alanoc8

I see you use a Xialla ring and with great success.I am always interested in trying new kinds of cock rings.
How did you arrive at using this particular ring?

I've used all sorts of different cock rings to stay hard most of my later adult life. So I'm always on the lookout for something new. I can't remember how I heard about the Xialla ring but it looked interesting. It's a little pricey. I put it on before I inject and it keeps me hard better than any other ring I've tried recently.