FrankTalk.org

I don't inject much at all but when I do I will alternate right and left at 2-3 and 9-10 o'clock. Here lately, my 31 gauge needle isn't penetrating my penis like it use to......to the point where I won't even bother to inject at all. Sounds weird but this is serious. I will push the needle into the side of my penis and it will just "dent" and not penetrate. I don't push too hard because I'm afraid I might injure myself. I find it weird that the needle use to go in like butter but now it would take MUCH MORE FORCE (which I won't do) for the needle to penetrate. Any thoughts?

My guess is your needles have dulled. I would try another brand or at a minimum buy a few new ones.

How long have you been injecting? Maybe the issue is scar tissue? I don’t think you would cause any harm by pushing through the resistance. I find resistance on occasion. It does not stop me. I’m still ok. It’s your choice, of course.

As Musson said, I’ve had a bad batch of needles that were just dull. You could visibly see the tips didn’t come to a needle point. Threw them away. One one isolated occasion I had a needle that had a bur on the end that allowed it to go in but hung on the removal so bad that it stopped and pulled out on the skin! I couldn’t figure what had happened and just yanked it out causing a small tear, and a lot of issue getting it to stop bleeding while my dick got hard in my hand! Ruined that night of sex with the wife as it took 20 minutes to stop bleeding and kind takes the mood away at the least.

Hopefully you are using a brand new needle every time.

I used to draw the medicine, put the (orange) cap back on, go to the backroom then inject.
I found that by putting the cap back on and taking it off to inject I often had trouble penetrating the corpus cavernosum.
I modified my routine by not putting the cap back after filling it with trimix.
Since modify my routine, I have not had difficulty injecting.

I don't remember where I saw it, but there was video that showed how these needles are very prone to dulling.
The dulling of these injection needles can make it difficult to injecting and cause unnecessary scar tissue.

Yeah, I did, as someone here suggested, bought a 40x magnification Loupe off Amazon.
I check each needle now before drawing up the medication. Every now and then I find one with a bit of shrapnel attached or a tip that doesn't look very sharp... definitely toss those. Of course, I did this after trying to stick myself one time and it hurt like hell and wouldn't go in. Took a look at the needle and it was really messed up... so I definitely check them out now before use. It seems about 1 of 10 fail the test. Good luck.

Thanks guys I thought it was just me.. Once I had resistance injecting a dose and looked st the needle under a magnifying glass and the tip was bent in restricting the flow. I''m wondering how often this happens and ithink you could be right about scarring. Maybe they cohld be damaged incerting them through the vial stopper. I will be checking them before use. Thanks again
.