Page 1 of 1
Trimix and shaft thickness
Posted: Fri Feb 08, 2013 1:07 pm
by shipper222001
Since i been injecting Trimix for almost 1 1/2 years, my wife and I have noticed that my penis shaft keeps getting thicker. We have been measuring it and it went from a little under 5'' to almost 5 3/4" in circumference at the middle of the shaft.. Even though I am pleased to have the extra thickness, Im a lttle concerned because i don't now why. Could the Corpus tissue be getting thicker or could scaring be causing it . My penis length is the same. and there is no bending to the sides. Also when me penis is flaccid the shaft skin is very saggy and droopy. It droops over the glans as if I had a foreskin. Anyone else experience this?
Re: Trimix and shaft thickness
Posted: Fri Feb 08, 2013 10:21 pm
by JimStars
Ship,
After almost two years with injections (but also 4 years pumping) my shaft is definitely thicker (by about .5" maybe?) when under trimix influence. Can't complain, and the Missus complains justttttt a little at first and then loves it ... which is good, yah?
J
Re: Trimix and shaft thickness
Posted: Sat Feb 09, 2013 11:16 am
by shipper222001
How much did you increase? wife loves my "gain" since Im not very thick.
Re: Trimix and shaft thickness
Posted: Sat Feb 09, 2013 7:45 pm
by dtwarren1942
In addition to Trimix (18 months), I also pump (3 years) and my girth has increased from 4.4 inches to 5.1 inches. I believe that the increase is a result of forcing additional blood into the CC as well as some fluid into the surrounding tissue such that the increased expansion forces the cells to expand or possibly multiply (mitosis) as a result.
Re: Trimix and shaft thickness
Posted: Mon Feb 11, 2013 4:27 pm
by shipper222001
Dwarren I think your assumptions are right about thickness and trimix. I also think that a little scaring may build up and result in an increase in thickness too.
AFTER all, an 1/4" increase in circumferece may not sound like much but when added to 5" its quite an increase. I do know the skin on my shaft is strecthed a lot in the flaccid state. Before I injected, it was tight even in the flaccid state and never covered any part of the glans. Now it covers almost the whole glan in flaccid which is ok.
I also noticed something else. Some times when I inject the needle encounters resistances. Other times it goes in smooth. I know Im injecting right because either way I get a very hard long lasting erection. Therefore i assume when I encounter some resistances its a little scaring. Comments?