hello all
i am just new to injecting and learning everything about this. can anyone please in layman terms describe the steps to take right after injecting in order for trimix to work effectively.
i have read about
1) holding and putting pressure on the injection spot for few minutes
2) massaging the shaft with fingers from the base of the shaft to the glans
3) pressing the perineum.
how much time do i have to do this for each of these things? please advise.
also what is the best technique to massage in order to distribute the meds to the entire shaft?
best practice to follow immediately after injecting
Re: best practice to follow immediately after injecting
I just compress the injection spot with my fingers using the same alcohol swab I used earlier and while doing so I move the fingers doing the compression up and down my shaft to help distribute the meds. Other methods you've read about here may work better but I've never tried them as I get sufficient results for me the way I'm doing it. You'll have to figure out what works for you.
R.R.P 2011 Mayo Jacksonville, Dr. M. Wehle. Not nerve sparing. C in margins. Radiation 2023, V.E.D, Viagra and PGE-1 (80mcg/ml) injections @ 8 - 14 units. Originally Edex20, then compounded PGE due to cost. Inject. 12 yrs. It works. Treasure coast of FL.
-
- Posts: 605
- Joined: Tue Feb 18, 2020 12:22 pm
- Location: St. Louis, USA
Re: best practice to follow immediately after injecting
The two corpora have a few fluid connections, so after injecting, you squeeze your length a few times between base and glans, maybe three locations, to get some Trimix into the other corpus. This encourages a symmetric straight-ahead erection.
Age 79 in 2024. On testosterone replacement due to hypothalamus malfunction. (Attention depressed guys: low testosterone is a cause.) Healthy health nut but ED due to getting old. Like to keep enough cardiovascular ability to thrust for 30 min.
Who is online
Users browsing this forum: Starbucks1 and 57 guests