Bent needle
-
owasso
- Posts: 13
- Joined: Mon Mar 25, 2024 7:46 pm
Bent needle
Inserted and was hard to press, pulled out and needle was bent, okay or not?
-
Comatose
- Posts: 44
- Joined: Tue Apr 09, 2024 6:23 pm
- Location: Annapolis, MD area
Re: Bent needle
owasso wrote:Inserted and was hard to press, pulled out and needle was bent, okay or not?
When I first started injecting, I bent the needle too. So not being thrilled with sticking a needle in my penis, I switched to trimix intraurethral gel which works great for masturbating.
-
bldoink
- Posts: 3696
- Joined: Mon Apr 03, 2017 12:58 am
- Location: Fl.
-
Martin6469
- Posts: 747
- Joined: Tue Feb 18, 2020 12:22 pm
- Location: St. Louis, USA
Re: Bent needle
Agree with bldoink. I bend it when I hit the hard tunica (corpus casing) at a glancing angle instead of plumb. I straighten the needle, disinfect it in a cotton ball, and try again.
Age 80 in 2025. On testosterone replacement due to hypothalamus malfunction. (Attention depressed guys: low testosterone is a cause.) Healthy health nut but ED due to getting old. Like to keep enough cardiovascular ability to thrust for 30 min.
-
ElbowRoom
- Posts: 567
- Joined: Mon Mar 17, 2025 1:58 pm
Re: Bent needle
As long as it didn’t break off inside you’re fine.
58yo Coloplast Titan 28cm Penoscrotal with Dr. Hakky 10/21/2025.
Pre-op erect measurements:
8.5"L and 6.5"C
Post-op: 8”L and 6”C at one week.
Pre-op erect measurements:
8.5"L and 6.5"C
Post-op: 8”L and 6”C at one week.
-
TOSDMS
- Posts: 46
- Joined: Tue Jan 30, 2024 12:11 pm
Re: Bent needle
Had it happen a couple of times in 4 years using trimix i think it's because the needles are sometimes dull from the manufacturer other wise the needles just slide in with no effort
Who is online
Users browsing this forum: Bytespider, ClaudeBot and 22 guests
