FrankTalk.org

Just got my prescription, including 20 syringes.

My dose is supposed to be 0.4 ML

My syringes show graduations of 5, 10, 15,20,25, 30. THIRTY WOULD BE A FULL SYRINGE.

How do I determine what is 0.4 ml?

Mike Zee

The syringe package says: 3/10 ml/cc capacity.

HOPE THIS HELPS.


Mike ZEE

They gave you 30 unit (.3 ml) syringes. You can either inject two 20 units (one on each side) or get 50 unit syringes. Or, if there is additional room at the top of the syringe, guesstimate an additional 10 units.

Mike: How was your dose determined? They tried 5 on me first, not quite enough, 10 was way, way too much. I have settled on 6.

Yikes, if they'd given me 40 units for a starter it would have blown the end of my dick off, lol.

Andy425 wrote:Mike: How was your dose determined? They tried 5 on me first, not quite enough, 10 was way, way too much. I have settled on 6.

Yikes, if they'd given me 40 units for a starter it would have blown the end of my dick off, lol.

Andy, my Doc started me off with 0.3 Tri Mix. Then he sent me home with loaded syringe of double strength Tri Mix 0.3 ml. Told me if I didnt get desired results to increase dosage to 0.4 ml. Look like I'm going to have to buy larger capacity syringes, because I won't stick my unit twice if I dont have to!

Mike Zee

I just don't understand injecting quantities like that , my ED is so extreme that 100mg of Viagra does nothing . My Uro started me on .05 ml , or 5 units of a very weak formula , I was able to get maybe 75% . I am up to 12 units right now , which is perfect .....If I injected .4 ml , I would be in the ER for sure .
Are you sure about your dose , you aren't missing a 0 after the decimal point are you ?

Chuck