Page 1 of 2

Bi-mix was in hot truck for two days

Posted: Fri Aug 01, 2014 4:28 pm
by sliphill
I injected 10 units today, and it's the first time that it didn't work. I usually inject 7 units and a half hour later I'm hard for a good 1 1/2 hours. Did I ruin my bi- mix by it being in a 90 degree truck for a few days.

Re: Bi-mix was in hot truck for two days

Posted: Fri Aug 01, 2014 11:21 pm
by JimStars
Slip,

Lucky for you it is BiMix. The ingredients in BiMix won't deteriorate at room temp and do not actually require refrigeration. (But still you would probably want to keep it there to retard any possible bacteria/fungus/anything growth). At 90 degrees ... not sure. You are our test subject on that so keep trying the remaining mix.

I get my BiMix sent to me US Mail with no coolpaks or anything (even in summer and it is sent from Tennessee !). Always just fine (although I do keep it in a cool 50F fridge once I get it).

I guess just check the clearness of the solution before each use. Not sure if your 10u fail was just a coincidence -- could be you were anxious about having left it in a hot truck for days and that would dampen any erection.

Finally, 30 minutes or so til hard? That's kind of a long time -- 5 minutes oughta do it, but hey .. if it is hard after 30 and stays that way for an hour or more you are lucky and just fine.

Keep trying ,,,

J

Re: Bi-mix was in hot truck for two days

Posted: Fri Aug 01, 2014 11:44 pm
by sliphill
It was only my 5th injection. I guess it's more like 15 minutes that it takes. The 4 previous injections, I also took 10 mg of liquid cialis. I wonder If this was the reason it didn't work today, I didn't add cialis this time. I was able to jack it up though. Tomorrow I am going to try 15 units. I need to be careful though, as the first time I injected, I did 50 units, had a hard on for over 6 hours!

Re: Bi-mix was in hot truck for two days

Posted: Sat Aug 02, 2014 10:43 pm
by JimStars
Slip,

Bimix is by design not as strong as Trimix and the fact that you were using 7, 10 or 15u and getting OK results is pretty good. I think most anecdotal info here is usually in the 20 and 30 or more ranges. But each person using it is going to be somewhat unique in what it takes. For me, if i used BiMix it would require 25-50u to get satisfactory results for an hour or more. (I just use Trimix -- and a pretty strong mix too).

So it would be nice if you can get away with a tiny amount 7-15u but in the end it will have to be whatever it takes -- and your probably painful 6hr excursion at 50u means that you know you won't be needing anywhere near 50.

Cannot say about your Cialis addition. Some guys use it to help but most do not. Plus adding it would significantly increase the cost of each erection, yes?

J

Re: Bi-mix was in hot truck for two days

Posted: Sun Aug 03, 2014 5:21 pm
by sliphill
Ok Jim, thanks. I think I will try 15 units next time and see what this does. So you think it was not harmed by it being in the truck for a while. It wasn't in direct sunlight or anything like that. I think it's good. I was a little stressed the day it didn't work.

Or maybe I'll just go for 20 units. But if I stay hard too long, how much sudafed does it take to make your boner go soft? :D

Re: Bi-mix was in hot truck for two days

Posted: Mon Aug 04, 2014 12:35 pm
by vernus
I make use of trimix to more than 6 years and have firm erections. I always kept
in the refrigerator and when I travel I keep in a box with ice. I do this on the recommendation of labaratório that provides the trimix

Re: Bi-mix was in hot truck for two days

Posted: Tue Aug 05, 2014 9:02 am
by sliphill
Yeah, although bimix does not need to be refrigerated, I was told that by letting it get above room temperature for a period of time, it probably did degrade it some. I was told to increase the dose to compensate for the degradation. That will teach me to leave it in my truck. Going to try 20 units today, I will let you guys know how it works.

Re: Bi-mix was in hot truck for two days

Posted: Tue Aug 05, 2014 2:33 pm
by sliphill
Here we go again. Damn, I injected 20 units about 11:50am. I waited 10 minutes and it wasn't fully there, so I wanted a little more assurance, and did 5 more units. Well, it's 2:29, and my unit is still hard! I took 4 sudafed's about 25 min ago. Should I take more sudafed? Also, I have a hard time cumming on bimix, less sensitive. Anyone else experience this?

Re: Bi-mix was in hot truck for two days

Posted: Tue Aug 05, 2014 3:09 pm
by sliphill
Starting to go down a little. I guess I shouldn't have did that other 5 units. Can't stand these 3 hour hardons. :shock:

Re: Bi-mix was in hot truck for two days

Posted: Tue Aug 05, 2014 3:12 pm
by sliphill
My unit has always favored going to the left. But it looks like it's curved even more that way. Am I going to damage my unit by injecting? On 10 unit's the other day, I was able to jerk it to get it hard. It was a whole lot more sensitive. Maybe this is the amount I should take all the time, and just give myself a little helping hand to get it all the way up. :D