FrankTalk.org

I have been using trimix 16 units of 30-1-10 since about 1 month. Results have been inconsistent even though the same dose was used each time. 2/3 of the time I get good eretions, about 7 to 8, lasting about 45 mins to 1 hour. But about 1/3 of the time, totally no results, not even any slightest sensation or fullness. Injection techinque, position and angles were about the same each time. Injection technique verified by Uro's nurse to be correct. Solution only about 3 weeks' old, kept in fridge all the time.
Is inconsistency common occurrence with trimix? Anything else I can try or I should do?

Hi Newbie,

Not sure what to tell you, very new to this myself but extremely satisfied right now. I have not yet injected and got no results from the injection. It is amazing to me how the difference has been between .1 and .2 cc of Trimix. Doc gave me .1cc at the office for a first injection and it worked but only for a short time and with stimulation fairly constantly needed. .2 cc at home was there for a lot longer than I needed it and was a solid 5 star erection. Feel as though my dosage is going to be somewhere between .15 and .2cc.

Hey newbie!

If I hit the target, I always get a result; however, the quality of the erection is not always the same. They vary from 50 to 90 percent. Even if you think you are in the right position, a slight variation can cause the needle to glance off the tough tunica.

Hey Boondawg!

In the beginning I experienced that after the first two injections I was able to slowly reduce the dose on subsequent injections. Dropping from 45 units to 12 units over the next 6 or 7 injections. My Uro advised that blood forced into damaged tissue may have rehabilitated the tissue such that a lower dose achieved satisfactory results. But alas, after two years, I had to slowly increase the dose such that I am back up to 45 units.

Here's a suggestion to all of you!
1st before you inject, take your dick in your hand & do a few stretches prior to the injection. Then warm your dick to get the blood flowing by rubbing it in between yr palms in a back and forth motion. Once you do this you should be able to inject the trimix directly into the left or right side and as you inject all of the medicine. Before you take the needle out, pull back on the syringe to see if you have any blood in it, if so, push it back in, you should also feel a mild stinging sensation as you inject into the corpro cavernosa.

Then after you rub the alcohol swab over the injection site, pull on the head of your penis in a downward motion a few times, this should get the blood flowing and if you injected correctly you should start feeling your dick getting hard, massage yr balls too, they are all part of the process of getting aroused guys. Your nipples, your thighs all have nerves in them and they lend to the arousal process along with your mind and thoughts.

This works for me within 3-5 minutes and I know that we all are not made the same, but the basic structure is there.

Good Luck

Ruff is right on: Enlarge the target by getting at least some blood flowing; make sure you've hit the target by drawing back on the syringe to see blood; and then massage the penis to spread the happy juice up and down the cavernosa.

Greg

Gentlemen: Please Advise / Help.


Inconsistent Trimix. I purchase from Universal Men's Clinic for about $23- a pop. Pre-filled syringes on demand maybe 2 ~ 4 at a time.

Using Autoject - needle on 'C' depth.

From over the top - once ! (Sudafed and hot bath or cold bath ??)

to;

About perfect: once or twice.

to;

50- 75% Results - several times ... or worse yet,

to;

Nothing at all: All too often ! (especially on 'big' nights if you know what I mean ...)

Where to inject: 2 fingers from base at 2 - 3 O'Clock or 9 - 10.

Often takes 10 - 30 seconds to inject !! Sprays out all over if I pull out the needle....

Freeze or Refrigerate ?