FrankTalk.org

I am a newbie to injecting and am totally confused. I am using Bimix with an auto injector.
Injection 1- used 0.12ML and got 80-85% erection
injection 2- used 0.15ML and got 75-80% ( went for a home run, didn't happen )
injection 3- used 0.18ML and got 65-75%
injection 4- used 0.20ML and got 75-80%
injection 5- used 0.2 ML and got 60-70% ( bummer )
injection 6- Used0.22ML and got 60-65% ( bigger bummer )
injection 7- used 0.26ML and got 75-80% but experienced some pain the next day but not in the injection site?? More toward the tip.
Have had no problems with erections lasting too long, have not had a 90-100% yet so one wouldn't expect it to be a problem.

I am at twice the amount I started with and am getting less of a result. So far, the amount of the injection has had little to do with the results. Anyone else have a similar experience? Did it ever level out? Any ideas? I'm lost.

flatbush1

I was started with a very weak formula and ended up using 40 units to get a useable erection. I got a much stronger formula and it's much better with less of an injection.
I wouldn't worry too much about the variations of the dosages and their results. Keep going up, maybe in larger steps til you get good results.

Flat,

Sounds to me like you should just stay with .12 ml then!

Often some ideal amount of Bi (or Tri) will either give you a 100% er or it will give you something less and no amount of extra will push it to 100% ... your plumbiung and hydraulics will dictate which type you are. If you are a 100% er then extra injection amount will just keep it up there longer and maybe get over 100% or end up with 4 hrs erection. If you are a less than 100% er then you just get whatever noodle you get up to and extra formula will just keep it there for 1 2 3 or whatever hours.

Also with Bimix they USUALLY just use 30mg PAP and 1mg phent .. sometimes 2 mg phent. The thing is you can hardly dissolve more than the 30mg into 1 ml of water so that is why 30 mg is tops.

What was the strength of the BiMix you have then??

J

Thanks for the replies, my bi-mix formula is 30mg/ml papaverine, 1mg/ml phentolamine. Might have to move up and try tri-mix. I had a similar experience with Muse, higher doses did less. Jimstars you may be right, backing up to the original dosage or even less may be the answer.
Thanks again.

Flatbush