Fun With Velcro Cable Ties
Posted: Sun Sep 13, 2015 12:29 am
Here's an idea that might be helpful to those who are doing injections, but perhaps they are not going to the 110 percent level we all wish for. I had an old velcro cable tie that I experimented with along with Trimix shots. Even tho Trimix gives me a good erection, I'll have to admit it might be waning a little over the years. But gets the job done if done within an hour or so.
We've all seen ideas about adding a cock ring/osbon ring to help keep the Trimix in and not let it flush away too quickly. The velcro tie works the same way, but is infinitely adjustable. You can wear it lose or tight or adjust back and forth (and quickly). They sell these at Amazon -- nice festive colors too. They are a little pinchy/scratchy even tho they are soft on the inner side so I am looking for some softer ones but this one works nice and is only around 3/8" wide so does not interfere or get in the way of business.
The results speak for themselves really. If added shortly after injecting you will easily get to 110 percent with only a barely snug fit around the base of shaft (can also try balls and shaft -- it is just barely enough for that too). It gets you from less than 100% to that 110 level -- even painfully so -- in which case you have to back off a bit. But if you are waning after an hour or two a little cinch back up and you are at 110 again.
So this might work for those of you who almost but don't quite make enough for penetration or who get there but go down too quick. Adding a picture here so you can see what they look like. Will try to add some before during after pics of the results .. the final 110 version is just like what you get when you use a pump and rings but without so much cutting off of blood flow -- it stays mostly warm, except at the very tightest cinching levels.
I also find it is nice if you want to sleep practically the whole night with the remaining erection after using it - or if just a rehab injection.. really extends the life of big willie.
J
We've all seen ideas about adding a cock ring/osbon ring to help keep the Trimix in and not let it flush away too quickly. The velcro tie works the same way, but is infinitely adjustable. You can wear it lose or tight or adjust back and forth (and quickly). They sell these at Amazon -- nice festive colors too. They are a little pinchy/scratchy even tho they are soft on the inner side so I am looking for some softer ones but this one works nice and is only around 3/8" wide so does not interfere or get in the way of business.
The results speak for themselves really. If added shortly after injecting you will easily get to 110 percent with only a barely snug fit around the base of shaft (can also try balls and shaft -- it is just barely enough for that too). It gets you from less than 100% to that 110 level -- even painfully so -- in which case you have to back off a bit. But if you are waning after an hour or two a little cinch back up and you are at 110 again.
So this might work for those of you who almost but don't quite make enough for penetration or who get there but go down too quick. Adding a picture here so you can see what they look like. Will try to add some before during after pics of the results .. the final 110 version is just like what you get when you use a pump and rings but without so much cutting off of blood flow -- it stays mostly warm, except at the very tightest cinching levels.
I also find it is nice if you want to sleep practically the whole night with the remaining erection after using it - or if just a rehab injection.. really extends the life of big willie.
J