Page 1 of 1
Change in Trimix formula
Posted: Tue Mar 07, 2017 12:54 pm
by postra7777
Quick question. I was on a very low dose of Trimix (20 units 5 mcg PGE1, 15mg Papa, .5 mg Phento). I had mentioned that I hadn't gotten the firmness that I would really need but was satisfied with the 2 hour erection that that mix produced. My Dr then prescribed 50, 30, 1 formula at 10 units. I tried 10 unit and had the firmness but it hurt and didn't go down for 3 - 4 hours. I tried 5 units and still had a painful erection. Question is has anyone tried less that 5 units? Seems that there would be too little liquid to dissipate fully if I went to 2.5 units.
Re: Change in Trimix formula
Posted: Tue Mar 07, 2017 2:51 pm
by tarheelgwb
you are likely one of the few (me too) that cannot tolerate pge1. my trimix script is 30mg pap, 4mg phen, 5 mcg pge1, using 25 units.
i tried a 10mcg formulation initially, but got the pain in my d**** for a few hours, thus reduced to 5. that works fine. i can use 20units and still be fine. 30 units hurts more.... still lasts 1-2 hrs either way. keep the pge1 lower and try increasing pap and phen.
just my thoughts.
Re: Change in Trimix formula
Posted: Tue Mar 07, 2017 4:59 pm
by leesburg2013
Well 7777 you probably are very close to the perfect formula for you. I recommend you ask doctor to write you a script for 30/30/3. Should be very close to be best for you.
For now try 2.5 - it cannot hurt - easy for me to say
.
Re: Change in Trimix formula
Posted: Tue Mar 07, 2017 11:24 pm
by sliphill
leesburg2013 wrote:Well 7777 you probably are very close to the perfect formula for you. I recommend you ask doctor to write you a script for 30/30/3. Should be very close to be best for you.
For now try 2.5 - it cannot hurt - easy for me to say
.
Wow, my formula is 120 pg/ 30 pa/ 3 ph. I did 35 units tonight, and I didn't care if it got hard or not! It hurt like hell. Of course it did not get me hard enough for penetration. I'm really getting frustrated with this. I'm am really thinking about a implant.
Re: Change in Trimix formula
Posted: Tue Mar 07, 2017 11:54 pm
by rahod1
postra7777 wrote:Quick question. I was on a very low dose of Trimix (20 units 5 mcg PGE1, 15mg Papa, .5 mg Phento). I had mentioned that I hadn't gotten the firmness that I would really need but was satisfied with the 2 hour erection that that mix produced. My Dr then prescribed 50, 30, 1 formula at 10 units. I tried 10 unit and had the firmness but it hurt and didn't go down for 3 - 4 hours. I tried 5 units and still had a painful erection. Question is has anyone tried less that 5 units? Seems that there would be too little liquid to dissipate fully if I went to 2.5 units.
Try 3 units....no need to change formula yet. Make sure you FREEZE it because at 3 units it will last a long time!