FrankTalk.org

i have been told that tri mix comes in many strengths so would you all mind listing the strength of the mix you are using so i can tell how i compare. also i am in southern orange counry calif and need a close pharmacy, any suggestions. also would love a list of the various strengths of trim mix available as i would like to order the strongest and take less. any reason this will not work. thanks

i'm not home at the moment, so i don't have access to my vial...however, each of us is very different and the mixes are many. There's no set formulas. It's whatever your uro starts you with and you go from there. In the beginning, if he ordered a weaker mix, you will need to use more. If that's the case, the next time, you order a stronger mix....you keep doing that until you find the one that's right for you. So really, it won't be helpful to have other's mixes...

There is one component that can cause your dick to ache and your threshhold for that could be high enough it won't affect you. It doesn't hurt, just an ache, which you could find distracting. If that's the case, back off the dosage and see if that helps. The pharmacy will, over time, be able to make you the right mix. Just takes some trial and error, i guess you'd say. And BTW, I use 31 or 32 gauge needles half inch long. They're pretty pain free and would strongly recommend them.

One last thing is how long the injections last. The stronger the mix, the longer it'll last. Mine usually last about 3 hours. More mix means a harder erection and longer lasting. So that's another thing to consider. In my memory, it took me about 4 vials before I got it right. Lots of practice, which is fun, of course.

Steve

Tim..
My Trimix formula is:
30 Milligrams Papaverine,
1 Milligram Phentol
20 MICROgrams Prostaglandin E1

I started with 7.5 units.... Increased it to 10 units (extend erection time to over 4 hours)
then in small steps (an recording each dose as I went) to the point i am satisfied with now.
which is 5 units for a nice hard 2 hour erection

hope this helps

Bill

I started in Aug. with 30 units which provided very little help. I worked my way up to 45 units which produced a very hard erection which lasted 3.5 hours. I subsequently slowly reduced my dosage to 15 units which generates a hard erection lasting 1,5 hours with very little aching. This seems to be my ideal dosage after two months of adjustments.

I was wondering if any long term users of Trimix have experienced the need to make further adjustments after a year or two.

mine is
alprost .8
papa 22.5
phen .8


use 5 units on a syringe gradulated to ten
usally good for 90 to 120 minutes

dirtfrmr aka a golfer who is always in the dirt rather than the grass

My mix is:

Prostaglandin E1 5.88
Papaverine 18
Phententolamine Mesylate 0.6

The prescription labels this mix "standard"

I assume the actual mix can alter the effective dosage. My uro advised that the Papaverine is the primary ingredient causing the erection as well as the aching. The other two are used to reduce some of the side effects of the Pap, and to some extent improve its efectiveness.

Per the lable, my trimix is:

Papaverine 30
Phentolamine 1
Prostaglandin 20

I'm not sure what the numbers refer to. Maybe ratios? Like 30 parts Pap, etc.

Greg