Need Help. Nothing works

[seattlereign]

Im new here & this is my 1st post. Open to any advice or instructions. I can't get anything to work for erection.
Before prostetcomy, I could masturbate with no drugs but needed viagra or cialis to have sex. Marathon sex. Now, pills just seem to supply a lil blood but completely limp.
Tried trimix 2units after surgery in Apr. Had fun sex for a couple hours but the poor girl had to take me to ER. Amazingly scary how great pleasure can turn to great pain. I've learned; have Sudafed now.
Anyway, I have tried Trimix about 15 times since. Worked only twice more. When it works; awesome. I could poke holes in my walls if i wanted to, figuratively. Otherwise, No luck. Tried measurements from 0.2 to 0.5 as well as multiple attempts in one session. Trimix stays in freezer. Tried 3oclock, 2oclock, 9 and 10....near base, midline, No luck. The drug is doing something because my dick gets swollen and deformed, but not erect. ...very puffy but useless for sex. Lady friend says my dick gets very heavy. Cool, but not enough for me.
Tried 5/16 inch as well as 1/2 needle. To inject, I go in slow. I cant tell where Im physically at inside my dick like most guys can. I dont have the guts to aspirate...i wanna poke and quit. I bleed twice.
VED hurts and doesn't get me fully erection. As soon as VED is removed...quick deflation.
Finally, last week got Autoject El. No more pain! Anyway, set for 5/16 inch. Just puffy. Tried measurements from 0.2 to 0.4. Did repeated attempts again but dick just gets super puffy and sore for days after. Getting desperate. I can get off by masturbating but thats it. My lady friend has been very very kind and patient. I wanna poke her again. She deserves it. I dont mind eating pussy but, you know....
Any advice?

[newtoed]

I'm almost certain that it is your technique. When your penis is only swollen and "deformed" to one side it means you injected into the hard connective tissue of tunica not into the cavernosa.
Make sure you penetrate all the way.
Make sure you keep the needle in for a few seconds when using Autject, because it take a while for it to inject.
You don't have to run to the ER after two hours unles the pain is severe, your penis is getting cold and purple. Many here had 3-4 hour erections.
Keep trying: it's probably your technique.
All the best!

[bldoink]

I'm not a doctor or any kind of health care professional. Not even close. Any advice is based on my own layman experiences and may not be valid. Always consult and follow your doctors advice.

I agree with newtoed. You haven't perfected your technique yet.

If you haven't yet please read the last page or two of recent threads.

I hesitate to suggest this but you might be a candidate to watch my poorly done non-professional video: https://www.youtube.com/watch?v=1KocDkt ... e=youtu.be

There are other demonstration videos on YouTube worth watching.

I've found that if the syringe plunger is difficult to depress you're not in the sweet spot. When in the correct spot the syringe depresses easily.

Personally I wouldn't use an auto injector until you get your technique worked out. Then consider that option.

You might want to consider a not overly tight constriction ring right after injection to supplement it. Make sure it's one that can be removed reasonably easy when fully boned out. You wouldn't want to be stuck with a huge purple throbber and not be able to get the ring off. I use a set of cheap "Lyps" brand rings I get off of Amazon but use whatever works. One poster on this forum said his doctor recommended against this practice. I've never asked my doctor about it and I'm no doctor.

Good luck

[JimStars]

Seatl,

As mentioned ... maybe you are not injecting in the CC?

Also a very slim cause due to your "Trimix stays in freezer". Take a very close look at the vial (holding up to strong light) ..shaking it a little to see if there are any crystals floating around in there. If there are it means your Trimix is now greatly reduced in potency until the crystals are dissolved back. Might explain the ache too.

Also if just not getting inside the CC, make sure you are really plumping up. It gives a better target and less softness which might cause the CC to 'give' instead of allowing the needle to pierce. Do a search for 'plump' and read a few posts.

Finally, you are incorrectly listing your shots as .2 units.... i assume that is 20 units (or .2 ml ) . Please go back and edit your original post for accuracy for future references... thanks. (Maybe list your prescription values if you know it also).

J

[Larry10625]

Seatl,

As mentioned ... maybe you are not injecting in the CC?

Also a very slim cause due to your "Trimix stays in freezer". Take a very close look at the vial (holding up to string light) ..shaking it a little to see if there are any crystals floating around in there. If there are it means your Trimix is now greatly reduced in potency until the crystals are dissolved back. Might explain the ache too.

Also if just not getting inside the CC, make sure you are really plumping up. It gives a better target and less softness which might cause the CC to 'give' instead of allowing the needle to pierce. o a search for 'plump' are read a few posts.

Finally, you are incorrectly listing your shots as .2 units.... i assume that is 20 units (or .2 ml ) . Please go back and edit your original post for accuracy for future references... thanks. (Maybe list your prescription values if you know it also).

J

Please create a signature. It makes things much easier to answer your questions without asking a lot of questions. Here's how you do it
Click on your name in the top right corner and select "user control panel"

Then under the big letters "User Control Panel" there is a row of words... select "Profile"

Then down the left had side of the "User Control Panel" select "Edit Signature" (You might have Create Signature or something. I don't know exactly what you'll get because I already have a signature to edit)

Most guys put something like what I have, but you can put whatever you want. Here is mine -
"AMS 700 (18 + 2 rte's). Implanted March 30, 2017 by Dr. Brock of London, Ont, CANADA. Great surgeon. Went in to septic shock and had to have implant removed April 29, 2017. I'm from Belleville, Ontario, CANADA. Appt. for consult for second attempt is on November 6, 2017... I can't wait."

Don't get too carried away with the doctor like his name, address, phone number, etc (anything that looks like advertising for him).. you can certainly say Dr. Jones (great Dr.)

If you need further help, please ask, that's what I'm here for.

Larry
Moderator

[seattlereign]

Thank you guys. My lady friend watched several Trimix videos and tried some different things on my dick:

-Trimix stays in freezer -make sure to give time to thaw out. She rolled the vial over and over between her hands.
-I hold my dick, but dont stretch it
-Using Autojet, she went in at 2'oclock at angle more downward (I most tried horizontal 3'o clock)
-Used 1/2 inch needle (I'm not sure but it may or may not be too long. After sex we found blood on bed. I thought she was on period but she checked herself . Nope, blood stain on sheet must've been from me)
-Allow medicine to fully eject until needle empty...hold needle in place after inject for a few
-It worked. After we had sex, she gave me a high-five. Finally. She my sex nurse.

I hope we can be consistent now. I've failed on so many attempts in past. Your guys were correct. I was doing something wrong before.

[rahod1]

NICE!

[happycamper59]

I like the "high-five" part. That's great.

[seattlereign]

Im the OP and Im back again with bad news. Nothing is working again. We tried the steps I noted above..when we were successful. But no go. Tried once on left and once on right. Even tried with 2 units (was previously successful with 1 unit of same vial). There was blood on dick. Not appealing. Any more tips, ideas?

[bldoink]

If it works some times but not others I'm left with no other conclusion than it's your technique.

I'f you've read all recent posts in the "Injections" sub-forum, as in probably the last two pages worth, (It would take a while) then I'm not sure I have any other suggestions other than to go back to your doctor and ask for a lesson.

Others will differ with me but I'd suggest your work on and perfect your manual technique before going to the Autoject.

I'm in no way claiming this is the end all/be all of injection techniques or videos but did you try this method: https://www.youtube.com/watch?v=1KocDkt ... e=youtu.be

I feel for you and your frustration and hope you get it figured out soon.