Cycling for size increase

[Vermel01]

This question was probably asked somewhere in the forum. I’m 9 weeks out. I cycle two to three a day morning afternoon and night. After about 5 1/4- to 5 1/2 inches I can no longer squeeze the pump it hard. In the interim while pumping I twist, turn and bend my penis and try a few more pumps. Does this mean all the saline is in the cylinders or is there more but I have to keep cycling until my penis stretches a little more. I am not looking for 7inches lol. I would like to get close to 5.75-6 inches if possible. Any advice.
Thanks in advance.

[Alax2869]

No, there is more..
If all the Saline was in the cylinders, the bulb would go flat..
I saw most of my growth come between 3-4 months.
Added a inch in length, half inch in girth

[Vermel01]

Thank you for the prompt reply.

[Adamski]

No, there is more..
If all the Saline was in the cylinders, the bulb would go flat..
I saw most of my growth come between 3-4 months.
Added a inch in length, half inch in girth

Is that for real ? I’m 10 weeks since implant and have been worrying about my loss of size. I too find the bulb goes hard before I seem to get to full stretch ?

Thanks

[Witheringhog]

I tried to pump to the max 2x a day for 1 hour, it took about a year before I could make the full hour.

Thats normal for the pump to be hard when the cylinders in your cock are stretched to the same pressure your hand can provide. I use a two handed grip and i can add WAY more pressure on the bulb that way. My recommendation is figure out a good two handed grip, soak in a hot bath, try and add some mini pumps every 5-10 min for the full hour.

[Vermel01]

No, there is more..
If all the Saline was in the cylinders, the bulb would go flat..
I saw most of my growth come between 3-4 months.
Added a inch in length, half inch in girth

Thank you

[Vermel01]

No, there is more..
If all the Saline was in the cylinders, the bulb would go flat..
I saw most of my growth come between 3-4 months.
Added a inch in length, half inch in girth

Thank you

[Vermel01]

I tried to pump to the max 2x a day for 1 hour, it took about a year before I could make the full hour.

Thats normal for the pump to be hard when the cylinders in your cock are stretched to the same pressure your hand can provide. I use a two handed grip and i can add WAY more pressure on the bulb that way. My recommendation is figure out a good two handed grip, soak in a hot bath, try and add some mini pumps every 5-10 min for the full hour.

Thank you

[Adamski]

Thanks for the advice !!

[BillyBob51]

This question was probably asked somewhere in the forum. I’m 9 weeks out. I cycle two to three a day morning afternoon and night. After about 5 1/4- to 5 1/2 inches I can no longer squeeze the pump it hard. In the interim while pumping I twist, turn and bend my penis and try a few more pumps. Does this mean all the saline is in the cylinders or is there more but I have to keep cycling until my penis stretches a little more. I am not looking for 7inches lol. I would like to get close to 5.75-6 inches if possible. Any advice.
Thanks in advance.

I'm looking at this same situation, even size............
I'm at 3 mos post op, and cycling this same way. Stand up and walk around awhile, move my penis and scrotum around and up & down, then relax and try pumping some more. Sometimes I can get a few more good pumps before it gets hard again. I do stay maxed longer than an hour.
I can reach about 5.25 when maxed, but hoping for at least 6"+. So gonna keep on cycling.
Good luck to you.