At what point do you know you pumped your Titan to full capacity?

[edjohn]

Here are Titan’s recommended fill volumes. For those who ran out of fluid, what volume is mentioned in your operative reports?

He didn’t have the notes but said he put 140mL. I just ran out at 8 months which makes it almost undeniable in my mind… implants can increase well beyond spec.

[Texas Otter]

How did you know that you have run out of fluid? I think I am dealing with a similar situation at 7 months

[GoodWood]

How did you know that you have run out of fluid? I think I am dealing with a similar situation at 7 months

If you pump to maximum inflation and the bulb becomes flat (or partially flat) and does not refill, it usually means there is no more fluid left in the reservoir—you have transferred all of the available fluid into the cylinders.

If this happens consistently at the same point during inflation, it suggests a fluid-volume issue. If it happens only occasionally, or at different points during inflation, I would be more suspicious of a mechanical problem with the pump itself.

If you’re unsure which is the case, your surgeon can help evaluate the device and determine what’s going on.

[materix]

When the bulb gets rock hard, is it most often caused by that the cylinders are full, or because the tunica can not expand more? How would you tell the difference?

[learnmore]

I asked this same question to my Dr at my 6 weeks post-op appointment.
He says pump until pump get too hard to squeeze.

[edjohn]

When the bulb gets rock hard, is it most often caused by that the cylinders are full, or because the tunica can not expand more? How would you tell the difference?

When the cylinders are full, it takes both hands to get any more pumps in. When the tunica is full, you are in pain. Right now, when I get to flat bulb, both are true, which probably means he used the ideal fill volume. From here on out, I am just aiming to get the pain to dissipate at that level of hardness.