Please help

[ED2013]

I couldn't resist inflating. I didn't do it 100%. I can't find the deflate button because I think it's too close to my testicle. I'm stuck most of the way hard and it HURTS!!!!

What should I do?

Also, I'm looking at a 4" dick when it used to be 5.25".

Is it safe to leave it hard for a week?

What you have to do is feel behind the pump w/ your index finger. Follow it up to the deflation block. If you have the rubber model, you'll see some circular ridges...that's where your index finger needs to be...on the other side of the block is the deflate button...press your index finger on the back of the block, then at the same time press your thumb on the button. Practice this on the rubber model, then try it...when you hear the buzzing of the valve, you'll know you've done it right. As for your length: almost guaranteed that you're no way close to full inflation. It'll be very uncomfortable when you cycle it, especially because you're still healing. Everybody here will tell you to be patient.

The problem is that it's too close to my testicle. The testicle is in the way. I heard a slurping sound for a little bit and I'm pretty sure it deflated a little, but now I can't get it again.

If you haven't pumped it since, it'll still be in deflate mode. Squeeze the fluid out of your penis.

[RichardTheFrog]

...you'll hear a buzzing sound from the valve. If you've hit the deflate button and heard the sound for a few second, you should be able to drain the rest out by squeezing/wringing out your penis...

Didn't work.

I think I need to squeeze the button once again, but the ball is in the way!

[ccrider]

...you'll hear a buzzing sound from the valve. If you've hit the deflate button and heard the sound for a few second, you should be able to drain the rest out by squeezing/wringing out your penis...

Didn't work.

I think I need to squeeze the button once again, but the ball is in the way!

Can you get your index finger behind the pump, then follow it up to the back of the deflate block? The other "hack" you can try is to squeeze the ends of the deflate block for about 4 seconds...does a reset of the deflate button etc...

[RichardTheFrog]

...you'll hear a buzzing sound from the valve. If you've hit the deflate button and heard the sound for a few second, you should be able to drain the rest out by squeezing/wringing out your penis...

Didn't work.

I think I need to squeeze the button once again, but the ball is in the way!

Can you get your index finger behind the pump, then follow it up to the back of the deflate block? The other "hack" you can try is to squeeze the ends of the deflate block for about 4 seconds...does a reset of the deflate button etc...

I can push the button and squeeze the deflate block, but it doesn't deflate.

[ED2013]

Steady the pump with one hand and push the button hard with the other

[RichardTheFrog]

I'm pretty sure squeezing the ends of the block just worked!!!

Okay so I'm bionic now.

How often should I cycle?

[ccrider]

I'm pretty sure squeezing the ends of the block just worked!!!

Okay so I'm bionic now.

How often should I cycle?

Try squeezing the deflate button now and see if you hear the buzz. You have to have one finger behind the block while you push down on the button. One problem I had was steadying the entire deflation block...it tended to angle either to the side or toward the top... Helps if you sit down in a chair with your package hanging over the edge...

[RichardTheFrog]

I'm pretty sure squeezing the ends of the block just worked!!!

Okay so I'm bionic now.

How often should I cycle?

Try squeezing the deflate button now and see if you hear the buzz. You have to have one finger behind the block while you push down on the button. One problem I had was steadying the entire deflation block...it tended to angle. Helps if you sit down in a chair with your package hanging over the edge...

That's the problem is that on the other side of the block is my testicle. That's why it was so difficult in the first place.

[alibaba]

Get your ball sock real hot and slack first. Sit in a hot tub,put your lap top on your lap a while to warm things up. Feel around a bit. One side of the block has a deflate button. Easier to find when things are slack. Roll things around a bit. See if you can turn the pump some if need be. At first the button is hard to push for release but gets better. You'll think you are going to jump out of your skin or damage something squeezing so hard but in time you get used to it.

[RichardTheFrog]

Get your ball sock real hot and slack first. Sit in a hot tub,put your lap top on your lap a while to warm things up. Feel around a bit. One side of the block has a deflate button. Easier to find when things are slack. Roll things around a bit. See if you can turn the pump some if need be. At first the button is hard to push for release but gets better. You'll think you are going to jump out of your skin or damage something squeezing so hard but in time you get used to it.

The problem is that in the other side of that button, where I should be holding is my left testicle right up against the deflate box. I have been having luck squeezing the ends of the deflate box and have cycled twice now. It's going to have to wait for my pump to come free to go directly for the deflate button.