Paul Perito talks about Floppy Glans - confused?

The final frontier. Deciding when, if and how.
Waynetho
Posts: 1768
Joined: Wed Nov 27, 2019 11:22 pm
Location: Dallas, TX

Re: Paul Perito talks about Floppy Glans - confused?

Postby Waynetho » Wed Feb 12, 2020 9:19 pm

LeRoastBeef wrote:Hi Waynetho, have you thought of using a cock ring with your implant?
I intend to when i get mine, as it gives me a firm glans.
It makes the world of difference.


I've tried a gel ring and it works to a degree but my tubes and corporotomies are literally right on the surface (15 cm implant, 15 cm cock length), so the ring gets all in the tubing when I put it on the base and typically rolls down a bit. Not ideal.

544kenmatt wrote:i wonder if urethral trimix would make a difference....


As to urethral trimix, JH2007 suggested (maybe in a PM to me) about using TriMix gel on the glans for engorgement. The problem with Trimix and similar drugs, they increase the blood flow through the arteries feeding the erectile tissue. If you're pouring water in an open ended tube (leaky veins), it runs right through. I doubt trimix will work with VL, but I'm not a doctor and I could be wrong.
62yo, married 41 yrs. Urolift (x4) 8/12/19. AMS 700CX 15cm (no RTE) penoscrotal 10/28/19, Frisco, TX. PD 1995/ED 2011. Cialis helped but hinged. (1995)L:6/G:5.5+, (2019)Pre-op L:5/G:4.5, (2/2020)L:6.0/G:5.0

oldbeek
Posts: 2547
Joined: Sun Sep 10, 2017 1:46 pm
Location: Los Angeles area

Re: Paul Perito talks about Floppy Glans - confused?

Postby oldbeek » Wed Feb 12, 2020 11:29 pm

I had my nerves that engorge my glans removed during RP. I don't have venous leaks. so maybe try-mix gel would help. Tri-mix did give me total engorgement and stiffness< BUT,, It gave me an allergenic pain that was about 9 out of 10._____ BACK to the original post. ____Watch and listen to what is said in the meet the penis ,Perito video. You can end up with a floppy head and it is out of the control of the surgeon,,IF.. If you have packed fibroses in the tip of your tunica's that can't be removed, the implant is hinged on the tip because implant tubes can't be pushed into the tip. At least that is what I saw.
82, good health, RP 7-2017, all nerves taken , PSA 0.05, 4-18,, .07 1/19,.05 4/19, .03 11-21, .04 11-23, implanted 4-1-18, Infra-pubic, AMS lgx 15 cm with 5cm rte. Implant at USC Keck. Dr Boyd and Dr Loh Doyle 6.5 x 5, 800 AUS 7-21-20

LeRoastBeef
Posts: 681
Joined: Mon Sep 17, 2018 11:09 am

Re: Paul Perito talks about Floppy Glans - confused?

Postby LeRoastBeef » Thu Feb 13, 2020 7:16 am

Waynetho wrote:
LeRoastBeef wrote:Hi Waynetho, have you thought of using a cock ring with your implant?
I intend to when i get mine, as it gives me a firm glans.
It makes the world of difference.


I've tried a gel ring and it works to a degree but my tubes and corporotomies are literally right on the surface (15 cm implant, 15 cm cock length), so the ring gets all in the tubing when I put it on the base and typically rolls down a bit. Not ideal.


You could try an osobon tension band, these are much tighter rings, which are very flat, so you could wear them further up the shaft, beyond your tubes. They are wonderful.

Also, is your 15cm including both the internal and external penis? (From the crux to tip).
Implanted with AMS 700 lgx, 2021.
30's
UK

Waynetho
Posts: 1768
Joined: Wed Nov 27, 2019 11:22 pm
Location: Dallas, TX

Re: Paul Perito talks about Floppy Glans - confused?

Postby Waynetho » Thu Feb 13, 2020 8:53 am

My cylinders are CX 15 cm with no RTE. My penis length is right at 15 cm from base to tip. Subtract a tiny amount due the glans over the tips (0.25") and the cylinders bottom out just below the abdomen, approximately at the pubic bone, where I have about a 1-2 cm thick fibrotic mass in the right side corpus cavernosum.
62yo, married 41 yrs. Urolift (x4) 8/12/19. AMS 700CX 15cm (no RTE) penoscrotal 10/28/19, Frisco, TX. PD 1995/ED 2011. Cialis helped but hinged. (1995)L:6/G:5.5+, (2019)Pre-op L:5/G:4.5, (2/2020)L:6.0/G:5.0


Return to “Implants”

Who is online

Users browsing this forum: AntonS, Indianaguy, niall4473, wilsonmill and 450 guests