FrankTalk.org

Can you be too narrow for an implant?

I do not know for sure. You would need to see a doctor. They do make narrow cylinders.

I’m 12cm circumference flaccid


Eid did say it’s
Possible to be too small for an implant but didn’t give me an actual number

LBC2020 wrote:I’m 12cm circumference flaccid


Eid did say it’s
Possible to be too small for an implant but didn’t give me an actual number

I don't think you have a concern for even a narrow cylinder. Should be able to have the regular cylinders. That is if there is no scarring or plaque. That usually causes a curvature of some sort. But there can be some in the Crus inside your body but I think you are early enough for that not to be a problem. If there is a little bit your doctor can remove or treat it during surgery. What is your girth erect?

The average circumference is 9-10cm flaccid.

I can’t find anything about average penile circumference anywhere

Anyways

If I’m about 11.5 cm circumference really soft
And 14.5 hard

Do you think that’s enough girth for an
Implant?

Anyone on here have a skinny penis ?

LBC2020 wrote:If I’m about 11.5 cm circumference really soft
And 14.5 hard

Do you think that’s enough girth for an
Implant?

I think it's ok. It's a good girth. What matters is your hard circumference.

I have a 13.5 cm circumference at the base, but it starts to narrow and it's 11cm below the glans. This narrowing was caused by Peyronie plaques, so I also have this concern about being too narrow for an implant.

Is that hard your talking about?

Tortão wrote:

LBC2020 wrote:If I’m about 11.5 cm circumference really soft
And 14.5 hard

Do you think that’s enough girth for an
Implant?

I think it's ok. It's a good girth. What matters is your hard circumference.

I have a 13.5 cm circumference at the base, but it starts to narrow and it's 11cm below the glans. This narrowing was caused by Peyronie plaques, so I also have this concern about being too narrow for an implant.

Are you hard or soft in this measurement

Hard