FrankTalk.org

how many times did you press to fill the implant pump and which company do you have?

I usually do ten to twenty squeezes to start playing and add to a total of forty for "The Action"....

Takes my Titan about 35-40 pumps depending on how many full pumps vs partial pumps I get.

I hear some say 30-40 seems like a lot to me, I pump 10-12 times.

nick40 wrote:I hear some say 30-40 seems like a lot to me, I pump 10-12 times.

this is because different people have different cylinder lenghts. The pump will stay the same, so with one press, you will pump the same amount of fluid, but if you got a longer cylinder, you have more fluid to be pumped, so you need to pump more often.

nick40 wrote:I hear some say 30-40 seems like a lot to me, I pump 10-12 times.

I too seem to max out with about 12 pumps, maybe 14 pumps on a good day.....Using AMS, Mr Winkie is only 5 1/2 inches when pumped to the max, but thicker, wider, and harder than original before implant. I was very disappointed with the lost of length. Lost over an inch due to ED, but my URO advised me of this lose at the time of my interview with him. Of course, I thought he was kidding. I used the VED pump, during ED, but didn't help much in saving my length. I remember my question to him, What am I to do with only 5 1/2 inches?. As they say, I'm a grown azz man, but I guess something is better than nothing.

I am about 13-15 full pumps then another 5-10 half to micro pumps

I don’t know if my equipment is faulty, or my technique, or what.

This goes back to starting to cycle on about day 3. I couldn’t feel the bulb squeeze at all. But I could feel fluid moving and I got an erection. And afterwards I got the “buzzzzzz” when I’d mash the deflate button.

So instead of anything resembling a normal squeeze, I mash what feels like a rock. The first dozen or so times I can feel the bulb actually give. After that I’m moving fluid but the bulb doesn’t feel like it did anything.

Little squeezes. Between 65 & 80. I’ve gone as high as 100.

I’ve never run out of fluid. The bulb has never gone flat.

I don’t know if it’s true but I think the more I pump, the higher the pressure within the cylinder. The higher the cylinder pressure, the bettter my chances of expanding the LGX to its maximum potential size.

One thing I’ve noticed: if I give it fewer than 50 or 60 squeezes, I don’t get as good an angle. In fact, it takes 50-60 squeezes to avoid a bit of a banana curve.

But…..it’s been in me over 4 1/2 years. It works great! So I’ll be damned if I’m gonna whine about a bit of strange behavior while inflating.

This really varies a lot depending on the size of the device and volume needed to fill the cylinders and hand strength. And pumps will very a bit as they are different sizes. Makes no difference how many it takes as long as it works. I will go to over 100 very fast partial pumps most times. And then add more to get to max and keep it at max when cycling. That gets me max length. If I do slow full collapsed pump bulb slow pumps then less than 20 and I get more girth and less length. Device in in my signature below.

Third week of cycling, I’m totaling around 20-22, ouch!