FrankTalk.org

I couldn't resist inflating. I didn't do it 100%. I can't find the deflate button because I think it's too close to my testicle. I'm stuck most of the way hard and it HURTS!!!!

What should I do?

Also, I'm looking at a 4" dick when it used to be 5.25".

Is it safe to leave it hard for a week?

Email Dr. Kramer. Maybe he can walk you through the deflation over the phone.

stiffupperlip wrote:Email Dr. Kramer. Maybe he can walk you through the deflation over the phone.

I have a model of it, I just can't locate the parts because it's too close to my testicle.

About your size you are seeing it without glans engorgement, then that could affect your perception

Try to relax and gently massage the pump away from the testicle and feel for the button. Try not to panic and take it slow and easy.

RichardTheFrog wrote:I couldn't resist inflating. I didn't do it 100%. I can't find the deflate button because I think it's too close to my testicle. I'm stuck most of the way hard and it HURTS!!!!

What should I do?

Also, I'm looking at a 4" dick when it used to be 5.25".

Is it safe to leave it hard for a week?

What you have to do is feel behind the pump w/ your index finger. Follow it up to the deflation block. If you have the rubber model, you'll see some circular ridges...that's where your index finger needs to be...on the other side of the block is the deflate button...press your index finger on the back of the block, then at the same time press your thumb on the button. Practice this on the rubber model, then try it...when you hear the buzzing of the valve, you'll know you've done it right. As for your length: almost guaranteed that you're no way close to full inflation. It'll be very uncomfortable when you cycle it, especially because you're still healing. Everybody here will tell you to be patient.

ccrider wrote:

RichardTheFrog wrote:I couldn't resist inflating. I didn't do it 100%. I can't find the deflate button because I think it's too close to my testicle. I'm stuck most of the way hard and it HURTS!!!!

What should I do?

Also, I'm looking at a 4" dick when it used to be 5.25".

Is it safe to leave it hard for a week?

What you have to do is feel behind the pump w/ your index finger. Follow it up to the deflation block. If you have the rubber model, you'll see some circular ridges...that's where your index finger needs to be...on the other side of the block is the deflate button...press your index finger on the back of the block, then at the same time press your thumb on the button. Practice this on the rubber model, then try it...when you hear the buzzing of the valve, you'll know you've done it right. As for your length: almost guaranteed that you're no way close to full inflation. It'll be very uncomfortable when you cycle it, especially because you're still healing. Everybody here will tell you to be patient.

The problem is that it's too close to my testicle. The testicle is in the way. I heard a slurping sound for a little bit and I'm pretty sure it deflated a little, but now I can't get it again.

P.S.: the concept is to simultaneously press the deflate button while pressing against the deflate block on the exact opposite side of the deflate block. However you're able to do that is what you have to do to deflate. The method I described works for me...

...you'll hear a buzzing sound from the valve. If you've hit the deflate button and heard the sound for a few second, you should be able to drain the rest out by squeezing/wringing out your penis...

ccrider wrote:...you'll hear a buzzing sound from the valve. If you've hit the deflate button and heard the sound for a few second, you should be able to drain the rest out by squeezing/wringing out your penis...

Okay thanks I'll try that