Injection location

[rocketman36419]

Good morning all!.

I have been reading posts saying that the most critical success for Trimix is to inject correctly. I never had the Dr. appointment showing me how to inject.

I am brand new to Trimix; only my second injection. And I wanted to get more information from you on injecting properly. Can you give a rookie some advice?

Sincere thanks,
Rocketman36419

[bldoink]

I was posting links to a couple of very informative videos but I just retested the links and discovered YouTube removed them for being porn, which they weren't. So I'll have to edit the Documents Worth Reading List to remove the dead links. When I get the chance I'll see if I can find some other good educational videos.

I also did an amateur injection video I can PM a link to if you wish, if it still works. You can see if that gives you what you need. There are surely better instructional videos to be found. Another poster has referred to one a couple of times but I never saw a link to it. Let me know if you want the link to my crappy amateur video.

[rocketman36419]

You rock, bldoink! I tried to PM you but since I am new it is just stuck in the outbox. Could you send me the link to your video? rocketboy36419@gmail.com

[bldoink]

I sent you a link in PM in response to your PM.

There is still information in the "General" sub-forum in the "Documents Worth Reading List" thread: https://www.franktalk.org/phpBB3/viewtopic.php?f=3&t=9266. The video links in the Injection video's don't work. A doctor had a couple of YouTube videos that were pretty good. They were linked through a gay website of some sort to Youtube. The doctor was a little strange and the web site stranger but the instructional videos were good. Youtube deleted them as porn but they clearly weren't. I can never figure Youtube policies out.

I'd remove your email from your post as you may get loads of spam if you don't.

[flyingduck2019]

Rocketman, the videos talked about are good information. My only comment is that when I started using tri-mix injections and got my first one at the Uro office the doctor told me to insert the needle straight in from the side, not at an angle from the top. Since then I have injected both ways and found it all depends on how easy it is. It is easier for me on the right side as I am right handed. I switch each time and when I inject on the left I use a auto-injector as it makes it real easy. It will also be easier if you or your partner can get your cock to a simi-erect state. In this state you have a larger area to choose where you want the needle to go. Just my two cents worth.

[notaes]

There is an excellent video on you tube that addresses every aspect of injecting trimix, drawing up meds from vial etc. it’s fantastic. Wish I had seen this a few years earlier. Look it up on you tube you’ll be glad you did. It even address how to hold penis for injecting!

[bldoink]

Care to post a link to it?

[ftwabeck3533]

For what it's worth, here's two links on injecting with illustrations (no videos):
https://www.mskcc.org/cancer-care/patie ... on-therapy
https://www.ustoo.org/PDFs/Injection.pdf

The only problem I've had was injecting into a vein (unknowingly) and the Trimix was lost immediately into my bloodstream, no erection but no pain or other side effects. That happened once out of about fifty injections. The other 49 were rock-hard successes.

I also alternate left and right sides, using the 10am and 2pm method. Little easier on the right side, but with experience left side does just fine.

[rocketman36419]

This is very helpful, you guys rock!

[flyingduck2019]

For some reason when I am going to inject on the right side of my cock and I pull the head to my left there seems to be a large area visible to stick the needle in. When I go to the left side and pull my cock head to the right there seems to be a lot of skin (I am uncut) where I would stick the needle in. I usually use a 5/16 needle but maybe I should switch to a 1/2 inch just to be sure I inject into the right area.