formula potency versus volume

[sommers]

Fairly new to Trimix and still working on arriving at my optimal dose
However, am wondering the trade offs between the volume of the solution versus it's potency. For example--if you had a sub optimal dose -- could you increase it's effect/potency by simply injection a larger volume?
and vice versa--if you had too strong a dose--could you modify it by injecting a lower volume?
thanks!

[bldoink]

...

[sommers]

I guess I posed my question wrong (or maybe I don't understand this at all) . Here's another try

Let's say you have a mix at a certain potency of the 3 ingredients (Trimix) and it's in a certain volume

Would increasing the volume of that mix--increase it's effectiveness? (your reply seems to indicate it would not)

[bldoink]

...

[Stutz427]

Yes you can. My Dr. started me outwith a low dose low volume and asked me to increase the injections by 5 units each time until I got the results I wanted. Well went through the first vial and at the end was injecting 35 units with minimal results. Same with the second vial of a stronger dose. Am just starting the third vial and will again do 5 units and keep on increasing the dose until I get to an optimal level. For me I want to inject the minimal amount. Its cheaper that way and seems to leave more room to increase things. Besides the more volume seems to be more difficult to inject. At some point I suppose one does find the correct level but it can be a lot of trial and error

[GoodWood]

My trimix is 30mgpapavarine, 4mg phentolamine, 40mcg PGE1 per milliliter (I believe it’s per milliliter)

If I take double the volume I’m getting double the active ingredients.