Sharp edge/corner when the cylinders are deflated/bent

[Waynetho]

LS, I almost spit my Dr Pepper all over my screen. I just imagined someone with a rolling pin rolling out their penis... Then I saw the firehose image in my head... Now I can't get the image of a brass fire nozzle with a GLANS on the end out of my mind!!! Or a fireman holding the fabric reinforced firehose and at the end instead of a nozzle, it has a "NOZZLE" (dick head)...

Agfa, when I posted in February, exactly what I was doing was to take the head and tuck it under against the shaft and roll down while pushing down and in toward my pubic bone, eventually it folds once more into the penoscrotal area where my incision used to be.

I'm not doing that method very often anymore as I really decided that the flat edges of the cylinders don't really bother me after all and as long as I was aroused enough before deflation, it stays pretty plump anyway. Even if I just inflate and then deflate without arousal, it doesn't take long before the cavernosal tissues decompress again and plump everything back up to round instead of flat. The whole thing is an evolutionary process and what bothered me 3-4 months ago doesn't concern me as much now.

[Agfa13]

Hehehe...glad to hear that. I was going to try it, but I guess I will just change it up sooner or later to something that feels right to me.

[indusvalley]

I’ve noticed that everyone here complaining about dog ears around the sides of the penis have either AMS CX or Titan. What about folks who have AMS LGX? I have heard that LGX cylinder is made from softer material. Do you guys also have dog ears problem?

[Waynetho]

I’ve noticed that everyone here complaining about dog ears around the sides of the penis have either AMS CX or Titan. What about folks who have AMS LGX? I have heard that LGX cylinder is made from softer material. Do you guys also have dog ears problem?

The CX and LGX are both made of the same material but the Dacron sleeves on each are made differently. It's about the way the fabric is made. The CX is designed to stretch only in girth and the sleeve on the LGX is designed to stretch lengthwise too.

[Agfa13]

Indusvalley,

I think everyone has dogears, it is just a matter of degrees, meaning that if you are hung in a flaccid state, you probably won't have much, if any. If you are on the smaller side, more than likely, you will have them. This is because the tubing, if you look at vids of implants, is bigger than your dick! Where will the tubing go when relaxed?
When erect, the tubing has all the room it needs:)!
As time goes on, the kinks will become softer due to the body's warming up of the tubing...this can take months, maybe even years.
I got lucky this time around. The 1st time, I would have to watch the way I was putting/pulling my pants on/off. Mine was right at the top and bugged the &*^&^$&^%$# out of me. This replacement, kinks on the other side, but not so prominent:)

[indusvalley]

I’ve noticed that everyone here complaining about dog ears around the sides of the penis have either AMS CX or Titan. What about folks who have AMS LGX? I have heard that LGX cylinder is made from softer material. Do you guys also have dog ears problem?

The CX and LGX are both made of the same material but the Dacron sleeves on each are made differently. It's about the way the fabric is made. The CX is designed to stretch only in girth and the sleeve on the LGX is designed to stretch lengthwise too.

I am inclined towards getting a CX considering it’s more reliable than LGX but I haven’t heard any LGX members here complaining about dog ears. It’s always usually Titan or in lesser cases CX members who complain about the dog ears.

[LMCatman]

I have the same thing.... I rarely notice it anymore. Maybe because I tend to keep mine a little inflated so I can "dress" up and to the right. My first "botched" implant bent sharply to the left and my flaccid dick tends to want to (uncomfortably) migrate down to the left and curl up a bit. Dr Perito made my dick perfectly straight when inflated bit flaccid, it goes where it wants.

My first (bent) implant had to be totally inflated to get rid of the dog ears. My "Ferrari" (yes, I have ridden her that long) would complain about "the corner" if I wasn't fully inflated. But no "corner complaints" in the 6ish years since my first revision.

We all have had some issues with our implants. I've had plenty! But post-RP, I had resigned myself to "soft dick blowjobs" and eating pussy.....my absolutely favorite activity.... My implant(s) have allowed me to have more fun than I'd ever dreamed of.

Good luck guys and....keep fucking!!!