Regain length & girth after implant

[aslanglobal]

Easy solution: pump daily until you don't need the ring




quote="2435tjklAS"]

Cycle as much as you can stand, start doing the bending procedure and also use a VED as much as you can stand. Just make sure to use one with a ring on the bottom of the cylinder. Mine is 2 1/2 inches wide at the base.

You sure about that? I don't think you're supposed to use any of the rings. My patient liaison at Boston Scientific wrote this in an email to me:

If you do utilize a VED, we recommend that you do not utilize the constriction band that comes with it, it will damage your device.

[/quote]

[riseagain]

When I first started using the VED after my implant I had the same problem with the discomfort and pain. I have two sizes of VEDS . One has a 2 inch base and the other has a 2.5 inch base with a ring for it. My smaller tube would put to much pressure on the tubes, so I tried the larger tube with the ring and have no problem with pain.

What happens is when you insert your shaft into the ring (use a lot of lube) the ring expands and doesn't put so much pressure on the tubes of your implant. It works for me. I do it both half way inflated and fully inflated. Love the results.

Just be carful, if it hurts then don't do it.