Change in Trimix formula

Sticking a needle Where? Courage, guidance and help.
Post Reply
postra7777
Posts: 154
Joined: Tue Aug 23, 2016 1:10 pm

Change in Trimix formula

Postby postra7777 » Tue Mar 07, 2017 12:54 pm

Quick question. I was on a very low dose of Trimix (20 units 5 mcg PGE1, 15mg Papa, .5 mg Phento). I had mentioned that I hadn't gotten the firmness that I would really need but was satisfied with the 2 hour erection that that mix produced. My Dr then prescribed 50, 30, 1 formula at 10 units. I tried 10 unit and had the firmness but it hurt and didn't go down for 3 - 4 hours. I tried 5 units and still had a painful erection. Question is has anyone tried less that 5 units? Seems that there would be too little liquid to dissipate fully if I went to 2.5 units.
Suffered with ED for most of my life. Viagra then to Trimix then implanted 3/8/2018 with AMX 700 CX 21cm with 1cm RTE. 50 years old Urolift procedure performed 30 day prior to my implant surgery.
Top
tarheelgwb
Posts: 143
Joined: Mon Apr 27, 2015 9:39 am
Location: jacksonville, fl

Re: Change in Trimix formula

Postby tarheelgwb » Tue Mar 07, 2017 2:51 pm

you are likely one of the few (me too) that cannot tolerate pge1. my trimix script is 30mg pap, 4mg phen, 5 mcg pge1, using 25 units.
i tried a 10mcg formulation initially, but got the pain in my d**** for a few hours, thus reduced to 5. that works fine. i can use 20units and still be fine. 30 units hurts more.... still lasts 1-2 hrs either way. keep the pge1 lower and try increasing pap and phen.
just my thoughts.
60 - Trimix user
Nerve sparring RP in March '15. Near zero natural Erections.
Top
leesburg2013
Posts: 132
Joined: Sun Aug 04, 2013 12:38 pm
Location: Denver, NC
Contact:
Contact leesburg2013

Re: Change in Trimix formula

Postby leesburg2013 » Tue Mar 07, 2017 4:59 pm

Well 7777 you probably are very close to the perfect formula for you. I recommend you ask doctor to write you a script for 30/30/3. Should be very close to be best for you.

For now try 2.5 - it cannot hurt - easy for me to say :).
WM 69 6'2" 192lbs, https://www.xtube.com/profile/leesburg2013-28635222 Quadmix injections PG/PA/PH/AT (70MCG/30MCG/3MG/0.15MG)ML Love Showers: http://www.silverdaddies.com/1511803
Top
sliphill
Posts: 1021
Joined: Mon Oct 29, 2012 8:27 am
Location: Charlotte, NC

Re: Change in Trimix formula

Postby sliphill » Tue Mar 07, 2017 11:24 pm

leesburg2013 wrote:Well 7777 you probably are very close to the perfect formula for you. I recommend you ask doctor to write you a script for 30/30/3. Should be very close to be best for you.

For now try 2.5 - it cannot hurt - easy for me to say :).


Wow, my formula is 120 pg/ 30 pa/ 3 ph. I did 35 units tonight, and I didn't care if it got hard or not! It hurt like hell. Of course it did not get me hard enough for penetration. I'm really getting frustrated with this. I'm am really thinking about a implant.
Ed (sliphill) 68

Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.

Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm
Top
rahod1
Posts: 397
Joined: Wed Jun 15, 2016 2:52 pm

Re: Change in Trimix formula

Postby rahod1 » Tue Mar 07, 2017 11:54 pm

postra7777 wrote:Quick question. I was on a very low dose of Trimix (20 units 5 mcg PGE1, 15mg Papa, .5 mg Phento). I had mentioned that I hadn't gotten the firmness that I would really need but was satisfied with the 2 hour erection that that mix produced. My Dr then prescribed 50, 30, 1 formula at 10 units. I tried 10 unit and had the firmness but it hurt and didn't go down for 3 - 4 hours. I tried 5 units and still had a painful erection. Question is has anyone tried less that 5 units? Seems that there would be too little liquid to dissipate fully if I went to 2.5 units.


Try 3 units....no need to change formula yet. Make sure you FREEZE it because at 3 units it will last a long time!
Top
Post Reply

Return to “Injections”

Who is online

Users browsing this forum: No registered users and 53 guests