If I may sliphill good advice:
In many of your threads you mention/ask about venous leakage. Your doppler said you have it so believe it even if some here say they are not accurate. You have also mention about getting or have new restriction band- well it should help but it still all goes back to your injection formula. You mention maybe you should try this or that- no maybe- your new formula is coming or here already. Start your quadmix at close to what your normal trimix units was and go from there. Yours seem as bad as mine so increasing it by 10units should not result too bad. JUST TAKE YOUR TIME AND INCREASE SLOWLY. If results are poor and then band does not help then obviously next step is implant. BUT, for these guys to help you need to try new formule, try band, and then everyone can help. GO FOR IT GUY- you can do it.
Quadmix
-
- Posts: 132
- Joined: Sun Aug 04, 2013 12:38 pm
- Location: Denver, NC
- Contact:
Re: Quadmix
WM 69 6'2" 192lbs, https://www.xtube.com/profile/leesburg2013-28635222 Quadmix injections PG/PA/PH/AT (70MCG/30MCG/3MG/0.15MG)ML Love Showers: http://www.silverdaddies.com/1511803
Re: Quadmix
leesburg2013 wrote:If I may sliphill good advice:
In many of your threads you mention/ask about venous leakage. Your doppler said you have it so believe it even if some here say they are not accurate. You have also mention about getting or have new restriction band- well it should help but it still all goes back to your injection formula. You mention maybe you should try this or that- no maybe- your new formula is coming or here already. Start your quadmix at close to what your normal trimix units was and go from there. Yours seem as bad as mine so increasing it by 10units should not result too bad. JUST TAKE YOUR TIME AND INCREASE SLOWLY. If results are poor and then band does not help then obviously next step is implant. BUT, for these guys to help you need to try new formule, try band, and then everyone can help. GO FOR IT GUY- you can do it.
Ok Lee, will do. I have to wait till next week to order. The Formula is 120/30/3/.2.
Ed (sliphill) 68
Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.
Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm
Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.
Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm
-
- Posts: 132
- Joined: Sun Aug 04, 2013 12:38 pm
- Location: Denver, NC
- Contact:
Re: Quadmix
A friend of mine who lives in Maine often sends me new cock rings they have in stock. He works in Adult-bookstore. Most of them are junk so I just throw away. So Monday I received the ring below - said its from china and new (not sure its new) anyway its 2 inch diameter and had 4 rings connected which is over 1 inch long -sure hides alot of your penis. So I got brave and put some vaseline on ring & penis and to my surprise slid on easily. Then I injected ONLY 10 units of Quad (120\30\3\.15), massaged slowly and only few minutes and results were not bad. Kind of uncomfortable and not sure I could use it for sex. Anyway for info only.
- Attachments
-
- steel-sleeve2 (640x502).jpg (155.34 KiB) Viewed 2564 times
-
- steel-sleeve (640x479).jpg (200.67 KiB) Viewed 2564 times
-
- image1 (640x640).jpg (197.29 KiB) Viewed 2564 times
WM 69 6'2" 192lbs, https://www.xtube.com/profile/leesburg2013-28635222 Quadmix injections PG/PA/PH/AT (70MCG/30MCG/3MG/0.15MG)ML Love Showers: http://www.silverdaddies.com/1511803
Re: Quadmix
This works wonders for me. You put it on 1st.
http://allknight.com/products/cock-enha ... kring.aspx
There are many others to look at but I suggest this one 1st
http://allknight.com/products/cock-enha ... kring.aspx
There are many others to look at but I suggest this one 1st
ocitgo (Bob F), Bremerton, WA
Implanted 11/13/2017 AMS 700LGX 15 cm, leak, 3 cm rear tip
Implanted 06/17/2019 AMS 700LGX 18 cm, 1.5 cm rear tip
Implanted 11/13/2017 AMS 700LGX 15 cm, leak, 3 cm rear tip
Implanted 06/17/2019 AMS 700LGX 18 cm, 1.5 cm rear tip
-
- Posts: 132
- Joined: Sun Aug 04, 2013 12:38 pm
- Location: Denver, NC
- Contact:
Re: Quadmix
Yes I heard others say that. Sure a lot of options for sizing - not sure which one to order and if Industrial is worth it?
The one I just tried is not very comfortable, very difficult to get off and takes up too much area of your cock. So threw it away. My friend has another in the mail.
The one I just tried is not very comfortable, very difficult to get off and takes up too much area of your cock. So threw it away. My friend has another in the mail.
WM 69 6'2" 192lbs, https://www.xtube.com/profile/leesburg2013-28635222 Quadmix injections PG/PA/PH/AT (70MCG/30MCG/3MG/0.15MG)ML Love Showers: http://www.silverdaddies.com/1511803
Re: Quadmix
The ring sizing is very important. They have a sizing instruction. I use a 2 inch.
ocitgo (Bob F), Bremerton, WA
Implanted 11/13/2017 AMS 700LGX 15 cm, leak, 3 cm rear tip
Implanted 06/17/2019 AMS 700LGX 18 cm, 1.5 cm rear tip
Implanted 11/13/2017 AMS 700LGX 15 cm, leak, 3 cm rear tip
Implanted 06/17/2019 AMS 700LGX 18 cm, 1.5 cm rear tip
Re: Quadmix
ocitgo wrote:The ring sizing is very important. They have a sizing instruction. I use a 2 inch.
I got a 2.0 inch horseshoe and tried it last night. It did not work for me. I took two of the little o-rings off of each side, it came with five on each side. Maybe I should put them back on and try it again.
Ed (sliphill) 68
Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.
Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm
Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.
Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm
-
- Posts: 132
- Joined: Sun Aug 04, 2013 12:38 pm
- Location: Denver, NC
- Contact:
Re: Quadmix
Just received this in the email this a.m. My friend said it should be a lot better slipping it around balls & then pulling cock in. He said since it is steel but extremely smooth will also make it easier to slip out of- the .5 w of frame will help this. Hope to try it on later tonight.
- Attachments
-
- cock-ring.JPG (133.62 KiB) Viewed 2444 times
WM 69 6'2" 192lbs, https://www.xtube.com/profile/leesburg2013-28635222 Quadmix injections PG/PA/PH/AT (70MCG/30MCG/3MG/0.15MG)ML Love Showers: http://www.silverdaddies.com/1511803
Re: Quadmix
[Slipill.....I got a 2.0 inch horseshoe and tried it last night. It did not work for me. I took two of the little o-rings off of each side, it came with five on each side. Maybe I should put them back on and try it again"
Yes, they are for sizing.
Did you use the sizing instructions.?
My size was 2 inches which maybe different than yours. I leave it on before I injection. Recently even without injetting I have a significant erection. That is new for me.
Yes, they are for sizing.
Did you use the sizing instructions.?
My size was 2 inches which maybe different than yours. I leave it on before I injection. Recently even without injetting I have a significant erection. That is new for me.
ocitgo (Bob F), Bremerton, WA
Implanted 11/13/2017 AMS 700LGX 15 cm, leak, 3 cm rear tip
Implanted 06/17/2019 AMS 700LGX 18 cm, 1.5 cm rear tip
Implanted 11/13/2017 AMS 700LGX 15 cm, leak, 3 cm rear tip
Implanted 06/17/2019 AMS 700LGX 18 cm, 1.5 cm rear tip
Re: Quadmix
ocitgo wrote:[Slipill.....I got a 2.0 inch horseshoe and tried it last night. It did not work for me. I took two of the little o-rings off of each side, it came with five on each side. Maybe I should put them back on and try it again"
Yes, they are for sizing.
Did you use the sizing instructions.?
My size was 2 inches which maybe different than yours. I leave it on before I injection. Recently even without injetting I have a significant erection. That is new for me.
Do you also have a venous leak? Think I'll try using it with all of the o rings on.
Ed (sliphill) 68
Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.
Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm
Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.
Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm
Who is online
Users browsing this forum: No registered users and 54 guests