Postby bldoink » Sat Dec 30, 2017 2:06 pm
I think I'm ready to try the Fleshlight program now. I got one of the Flight models. I thought the regular models were just too big. Girth I have but I don't have a 8+" long dick. I went for the flight Instructor model as that was one of the ones the Death Grip program recommended.
Problem, the length is perfect but it was way too tight. So, I went about modifying the thing. After modification and experimentation I think I finally got it right. It was trial and error but if it had been done logically and in order it would look like this:
Fleshlight Flight Modification procedure- The plastic ring at the opening was smaller than my required girth.
Solution:
- Remove cap and pull inner jelly sleeve from casing.
- Pull ring from mouth of casing. A little effort may be required as it snaps in and was held by mild silicone type glue.
- Chuck a 2" hole saw in the drill press and cut a hole out of 1/4" plywood
- Use hot glue and glue the 2" plywood disk in center of ring, making sure it's centered and flat. You can adjust before glue cools.
- Chuck a 2 1/4" hole saw in the drill press.
- Use the existing hole in the plywood disk to center and cut a 2 1/4" hole from the Fleshlight ring.
- Scrape and then sand the inside of the ring so it's smooth like factory work but not sharp. This gave me a finished diameter of 2.275" equaling a girth of 7.147, minus of course the space taken by the sleeve.
- Even with the opened up ring it was still too tight. Solutions:
- Remove inner sleeve from casing.
- Make sure the inner sleeve is well powdered with corn starch.
- With long sharp scissors completely trim off all 4 ridges running down the outside or the exterior of the sleeve.
- With the scissors cut 8 deep scallops into the thick inner rim of the sleeve. This was at the bottom of the rim that also helps hold the sleeve onto the previously altered ring. Leave enough to still hold the sleeve on the ring. Don't cut all of the way into where the ring actually sits.
The result of this modification will leave the sleeve fitting a bit loose in the casing but I've had no issues with them separating. I have no idea what these alterations will do to longevity but I'm sure it eliminates any warranty. The good news is that it now seems to work for me and I'll now be giving that program a try. If you aren't a bit girthy you just wasted your time reading this. Sorry!
R.R.P 2011 Mayo Jacksonville, Dr. M. Wehle. Not nerve sparing. C in margins. Radiation 2023, V.E.D, Viagra and PGE-1 (80mcg/ml) injections @ 8 - 14 units. Originally Edex20, then compounded PGE due to cost. Inject. 12 yrs. It works. Treasure coast of FL.