Penis pointing to left

[oldbeek]

If the syringe did not compress it was because the needle was lodged half way through the tunica wall. when plunger would not depress, you needed to jab harder to get through the tunica wall.

[spooon]

are you suggesting that if you poke too slowly then you simply nestle against the tunica wall as opposed to penetrate it? the needle went all the way in.

[bldoink]

I poke pretty slowly with good results. I usually can feel it pierce the tunica but not always. With the 12mm needles you may actually be going in too deep. You need to keep experimenting until you get more adept and comfortable with the shots. It might take a bit to get your depth figured out. It can vary depending on the location of the shot. After inserting the needle the depth you think is appropriate, try the plunger resistance. If too much resistance try a little deeper. But also don't be afraid to withdraw the needle some bit by bit as you check for plunger resistance. I use the 8mm needles but when I depress the plunger I actually have the plastic nipple of the syringe indenting my skin a substantial amount.

Good luck!

[spooon]

What do you mean by going in too far...you think if you penetrate too far that can also cause plunger resistance? To be honest I should try again on the left, i've only done it once.

Let's say you've got a flaccid penis length of 9cm, at what locations do you inject, 0cm being the base of the penis and 9cm the tip?

[bldoink]

I'm not a medical professional of any kind and nothing I post should be considered medical advice. Always ask your doctor and follow his/her advice.

What do you mean by going in too far...you think if you penetrate too far that can also cause plunger resistance?

Yes. While I'm no expert on anatomy it has been my experience that resistance can increase if you go too deep, although I'm not sure what structures you would be piercing to cause that result. There are times when I have to back out a bit. While I'm not generally a big advocate of aspirating, and I never look for or expect blood, I have at times found it helpful, when I've thought I was in the correct spot, to back out the plunger 1.5mm or so before pushing it down. This will help indicate if you're positioned correctly as it will be difficult to pull it back if incorrectly positioned. It also will free the plunger from it's initial resistance against the walls of the syringe, making it easier to depress, assuming of course you're in the right spot. I hope that train of thought wasn't too muddled.

Let's say you've got a flaccid penis length of 9cm, at what locations do you inject, 0cm being the base of the penis and 9cm the tip?

While I haven't seen it recommended in any medical literature or heard it from a doctor, for me, I feel anywhere from 9mm from the base to 9mm from the glans is fair game although too close to either end may be more painful and needle depth may well vary when at either extreme. Near the glans I've found shallower is the ticket, while near the base deeper is needed. Of course it's easier when more conventionally located but after many sticks I find it helpful to be able to branch out a bit.

Good luck!

[spooon]

Thanks Bidoink. I've just order my second batch of injections and will definitely refer back to this later.

[Tsanchez12369]

Caution! If the bend started after injections...stop and see MD immediately. Injections can cause peyronies which can worsen suddenly...mine is 90 degrees and wasting away as a result of peyronies due to injecting trimix.