I think my Titan was installed backwards???

[spirit]

For example as to what tomas1 is talking about, here's my picture from the day after surgery.

Did you have similar "eyes" on the head of your dick where the doctor pulled the suture material through to seat the tips in the glans.

snake-eyes.jpg

Nothing like that.

[Waynetho]

I was infrapubic and the tubes definitely are outside my body. They appeared to be at the base but once swelling subsided all the way, they are right there, a full 2" outside my body. I can also feel the tips near my anus plain as day.

I can plainly feel two small tubes and two larger ones well outside my body in the deflated shaft. They can be separated and counted and the two small diameter, harder tube extend at least 2" out, perhaps more. This is fact. There are not supposed to be four tubes in my actual penis according to any drawings.

Were you degloved for your implantation?

Not sure what that means.

With infrapubic, you have the tubing coming out the top of the corpora inside the body and then *UP AND OVER* to one side of the penis and down along the pubic bone and musculature to the scrotum. You will feel the tubing from the "up & over" approach.

Degloving means that they do a circumcision cut around the penis and slide the skin down to one's abdomen like a glove on a hand.

[Waynetho]

It sounds like an MRI or sonogram might get some answers. If it is as you're saying, that sounds like gross malpractice (hack job). I can't see that occurring from anyone who can read a technical manual from the manufacturer. Who was your surgeon?

[spirit]

I was infrapubic and the tubes definitely are outside my body. They appeared to be at the base but once swelling subsided all the way, they are right there, a full 2" outside my body. I can also feel the tips near my anus plain as day.

I can plainly feel two small tubes and two larger ones well outside my body in the deflated shaft. They can be separated and counted and the two small diameter, harder tube extend at least 2" out, perhaps more. This is fact. There are not supposed to be four tubes in my actual penis according to any drawings.

Were you degloved for your implantation?

Not sure what that means.

With infrapubic, you have the tubing coming out the top of the corpora inside the body and then *UP AND OVER* to one side of the penis and down along the pubic bone and musculature to the scrotum. You will feel the tubing from the "up & over" approach.

Degloving means that they do a circumcision cut around the penis and slide the skin down to one's abdomen like a glove on a hand.

No, no other incisions. These small tubes are in the shaft, they can be separated and counted. Two small hard ones and the softer larger ones. The entry point can be felt also, where the tube enters the cylinders. Plain as day.

Of a 20cm cylinder, how much is on the short end, the part that is supposed to be inside after where the tubes join? 1.75" or so? I swear that is in my shaft and does not extend to the glans.

[tomas1]

I agree with Wayne. If no snake eyes, you got short changed.

[Waynetho]

Of a 20cm cylinder, how much is on the short end, the part that is supposed to be inside after where the tubes join? 1.75" or so? I swear that is in my shaft and does not extend to the glans.

The Titan measurements are about 0.75 to 1 cm of hard plastic tip material at the distal end (in the glans) and about 4.5 cm of hard plastic tip material with the tubing exiting just behind where it attaches to the expansion material of the cylinder.

A 20 cm Titan actually has about 14.5 cm of expandable area, 1 cm of distal tip and 4.5 cm of proximal tip.

When deflated, how long is the hard plastic in your distal penis? It should be about 1 cm or about a third of an inch.

[spirit]

Of a 20cm cylinder, how much is on the short end, the part that is supposed to be inside after where the tubes join? 1.75" or so? I swear that is in my shaft and does not extend to the glans.

The Titan measurements are about 0.75 to 1 cm of hard plastic tip material at the distal end (in the glans) and about 4.5 cm of hard plastic tip material with the tubing exiting just behind where it attaches to the expansion material of the cylinder.

A 20 cm Titan actually has about 14.5 cm of expandable area, 1 cm of distal tip and 4.5 cm of proximal tip.

When deflated, how long is the hard plastic in your penis? It should be about 1 cm or about a third of an inch.

Thank you Wayne. That is NOT how this is. Measuring from my body: 2.25" consisting of (2) Cylinders and (2) hard tubes, 1.5" or so to the absolute tips of the cylinders then about .75"-1" for the empty glans. This can all be felt.

I can also feel those are pointed tips near my anus. I am not making this up.... sadly.

[spirit]

See pic. I can plainly feel this in my shaft. Those tips end right about where the glans begins. I can even feel the place where the tubes join and where the more flexible cylinders end. I can feel that "coupling" or whatever it is.

TitanTouchFullproductBL-SG.jpg (142.86 KiB) Viewed 1024 times

My pump is drawn well up to my body and have the reach way up there to get to the release button.

[spirit]

It sounds like an MRI or sonogram might get some answers. If it is as you're saying, that sounds like gross malpractice (hack job). I can't see that occurring from anyone who can read a technical manual from the manufacturer. Who was your surgeon?

Where would I go for that? To him?

[tomas1]

They do an ultra-sound of my bladder every time I go to the urologist. I'm sure it's to milk a couple dollars from Medicare.
I don't think it costs too much. MRIs are a different story.