Possible Pump failure or leak only 2 months after surgery

[Tokyo_123]

Here is some information from Coloplast if you'd like to read a bit. https://www.dropbox.com/s/jigjyy7sscflr ... e.pdf?dl=0

Thank you for this link.

[Clementis]

Thanks for the reply guys.
I have a Titan OTR 20+1RTE
I can add one more detail to the description of the problem that i've noticed today while inflating: after about 20 pumps the reservoir seems to be empty.
The shaft is very hard and i can arely bend it. So i'm near full inflation or fully inflated.
Then i wait about 30 seconds and try to give 2-3 more pumps. At this stage if i squeeze the pump GENTLY It gets soft and i can feel a fair amount of fluid going back to the reservoir. On the contrary, when i apply more pressure the bulb seems to be harder to squeeze. In the latter case the amount of fluid is less and i notice a slight increase in the hardness.
To sum up: this bulb softness i'm experiencing starts when i'm basically maxed out and i squeeze the pump gently and with slight pressure.
Go figure!

It sounds pretty clear to me that your surgeon didn't give you quite enough saline for your max length and girth. The good news is you can still get a rock hard boner that is more than enough for penetration. But I'll never understand why every implant surgeon isn't maxing out all their patients with 125cc's of saline. I know that's what Perito gave me, and I have a pretty normal-sized dick, 6 by 5.25.

To be honest if this was the reason i wouldn't be bothered.
When aroused i'm about 6.5 inches long. Girth is about the same as yours.
Considering that 1/3 of my 20cm Titan is inside my body i don't think there's too much space for further gains. I had scar tissue before surgery and i lost basically nothing.
So size wise i'm satisfied. I just want a functioning device and a reliable hardness.
The only think that worries me is that this strange bulb behaviour could be an indication of a leak. That's why i'm panicking.