AMS 700 CX Deflation Block Causing Scrotal Pain/Discomfort

[Merknaut]

I was implanted 2/12/2024 and my recovery has gone extremely well and I am very happy with the results. However, the deflation block on this unit digs into my scrotal wall and the skin in that area is extremely sensitive to any touch or rubbing and causes varying degrees of pain/discomfort.
The pump bulb and deflation block hang at a rotated angle so that the right side of the block protrudes toward the front of my scrotum.
(so looking downward and imagining a clock face that is parallel to the floor 12 o'clock to the front, the block is rotated to a position between the 1 and 2 o'clock position, when it should be resting at a 3 o'clock position)
It is in constant contact with the scrotal wall. I followed the doctor's instructions to pull down on the assembly 2 to 3 times a day during recovery and the bulb hangs down about even with my testicles in my scrotum. The problem is I can't seem to get the assembly to rotate to a more neutral position and stay there.
Has anyone else experienced something like this? Will my scrotum just get used to this? Is there any hope that I can get it permanently rotated to a neutral position?
Just looking for any insights you may have.
Just for visual reference:

ams-700-block.jpg (12.11 KiB) Viewed 395 times

[ED2013]

Try massaging the area and pull down gently in a hot bath at least once a day.

[oldbeek]

My surgeon has been doing them for 35 years. He said just leave it alone. I still had scrotal pain at over a year. You still have a lot to get used to. The tubing pressing up from inside gave me some pain also. IT WILL TAKE TIME to get used to it.

[newhope]

I was implanted 2/12/2024 and my recovery has gone extremely well and I am very happy with the results. However, the deflation block on this unit digs into my scrotal wall and the skin in that area is extremely sensitive to any touch or rubbing and causes varying degrees of pain/discomfort.
The pump bulb and deflation block hang at a rotated angle so that the right side of the block protrudes toward the front of my scrotum.
(so looking downward and imagining a clock face that is parallel to the floor 12 o'clock to the front, the block is rotated to a position between the 1 and 2 o'clock position, when it should be resting at a 3 o'clock position)
It is in constant contact with the scrotal wall. I followed the doctor's instructions to pull down on the assembly 2 to 3 times a day during recovery and the bulb hangs down about even with my testicles in my scrotum. The problem is I can't seem to get the assembly to rotate to a more neutral position and stay there.
Has anyone else experienced something like this? Will my scrotum just get used to this? Is there any hope that I can get it permanently rotated to a neutral position?
Just looking for any insights you may have.
Just for visual reference:
ams-700-block.jpg

it's too soon to judge. in the meanwhile please update the signature with implant size and size pre op and post op

[Jage64]

FWIW, my doctor places the block at your orientation purposely. He asked if I was left or right handed, and since I'm right handed he rotated the pump so the button faces 10 or 11 on the clock so that my thumb rests on it naturally when coming from my right side (so the block is oriented as if it's 7:05 or 8:10). I don't think there is a standard that says it should be facing forward, that would actually make the block wider between your testes and possibly more uncomfortable.