Partially Inflated For Weeks

[Irish Lad 34]

I'm 5 months out of penoscrotal implant surgery now. I have a 21 cm Titan (RTE included).

I only realised maybe 3+ months after surgery that I had been partially inflated all the time. I had mostly been going around all day every day with maybe 10% or 15% inflation.

It was only after I deflated myself while lying flat in bed one night, did I notice that my penis totally squished into an empty crisp packet. That was the aha moment when I realised I had fully deflated my implant to 0%.

A week or so after that I deflated nut left about 10% in again by mistake and accidentally left it like that for about a week.

So basically I've had some partial inflation most of the time with my implant.

I must say the fully inflated implant looks and feels a bit odd, whereas it looks and feels a bit more natural with maybe 10% inflation. With a few small pumps the penis kind of fills into a more natural more well structured shape.

Does a tiny bit of inflation all the time badly damage your penis or implant? I heard one person here say it totally does, but a bit more insight would be good. I just feel like it's way more natural with a tiny bit of inflation.

[LetoMan]

That’s probably a good question for your doctor, but if you want pedestrian opinions, here is one: the concern with never fully deflating your implant is that a capsule might form around your reservoir that doesn’t allow you to fully deflate it in the future.

I can’t think of why it would otherwise be a concern. But even that doesn’t strike me as serious. There is not a big difference between fully deflated and being at 15%.

Personally, sometimes I just want my big full dick to go away when I’m not using it. So giving it a little squeeze to get the last bit out feels good. Mine doesn’t look weird when I do so. But who is looking? Unless you are wandering around a nudist camp all the time, giving it a complete drain every now and then can’t be that big of a deal.

[JohnnyBorg]

That’s probably a good question for your doctor, but if you want pedestrian opinions, here is one: the concern with never fully deflating your implant is that a capsule might form around your reservoir that doesn’t allow you to fully deflate it in the future.

I can’t think of why it would otherwise be a concern. But even that doesn’t strike me as serious. There is not a big difference between fully deflated and being at 15%.

Personally, sometimes I just want my big full dick to go away when I’m not using it. So giving it a little squeeze to get the last bit out feels good. Mine doesn’t look weird when I do so. But who is looking? Unless you are wandering around a nudist camp all the time, giving it a complete drain every now and then can’t be that big of a deal.

Leto is right - not being fully deflated isn’t a major issue, I remember seeing this on one of Perito’s videos. He actually spoke in one also that some guys give a pump or two to help with dog ears and also mild dribbling, I believe.

[1sfman]

Personally, sometimes I just want my big full dick to go away when I’m not using it. So giving it a little squeeze to get the last bit out feels good. Mine doesn’t look weird when I do so. But who is looking? Unless you are wandering around a nudist camp all the time, giving it a complete drain every now and then can’t be that big of a deal.

Interesting LetoMan that you have the same setup as I do, AMS 700 CX 21 cm, and I'm assuming you have the MS pump. For me, after pressing the release valve, I squeeze my dick to get it fully "drained". But, after a few minutes, I have a bit of fullness in my dick. I wouldn't call it an erection, but it definitely isn't fully flaccid. I'm guessing there is some blood flow back around the cylinders causing the inflation. I tried after fully deflating pressing the pump slightly to lock the valve in the fill position. Same result, I get some inflation, so I know it isn't any backflow from the reservoir. I don't find it a problem, but it definitely has left me a shower.

Irish Lad 34, I don't think a small amount of inflation is a problem, but as LetoMan said, good question for your doctor.

All the best to you going forward with your Bionic tool.

[Rider1400]

Personally, sometimes I just want my big full dick to go away when I’m not using it. So giving it a little squeeze to get the last bit out feels good. Mine doesn’t look weird when I do so. But who is looking? Unless you are wandering around a nudist camp all the time, giving it a complete drain every now and then can’t be that big of a deal.

Interesting LetoMan that you have the same setup as I do, AMS 700 CX 21 cm, and I'm assuming you have the MS pump. For me, after pressing the release valve, I squeeze my dick to get it fully "drained". But, after a few minutes, I have a bit of fullness in my dick. I wouldn't call it an erection, but it definitely isn't fully flaccid. I'm guessing there is some blood flow back around the cylinders causing the inflation. I tried after fully deflating pressing the pump slightly to lock the valve in the fill position. Same result, I get some inflation, so I know it isn't any backflow from the reservoir. I don't find it a problem, but it definitely has left me a shower.

Irish Lad 34, I don't think a small amount of inflation is a problem, but as LetoMan said, good question for your doctor.

All the best to you going forward with your Bionic tool.

Most likely your getting feed back from that portion of your implant past where you can squeeze it! You can only squeeze from tip to base of shaft. There’s usually 3-5cms of implant still full of fluid that settles back evenly when your done deflating.

[RayChez]

I always leave it partially filled. If I completely deflate it all the way, the pump valve gets stuck. If I leave it partially filled I never have a problem. I usually leave like ten pumps most of the time. It also has helped in the stretching of the penis. I will not elaborate on that because many do not believe on it helps, but it does for me and that is all that counts.

[1sfman]

Personally, sometimes I just want my big full dick to go away when I’m not using it. So giving it a little squeeze to get the last bit out feels good. Mine doesn’t look weird when I do so. But who is looking? Unless you are wandering around a nudist camp all the time, giving it a complete drain every now and then can’t be that big of a deal.

Interesting LetoMan that you have the same setup as I do, AMS 700 CX 21 cm, and I'm assuming you have the MS pump. For me, after pressing the release valve, I squeeze my dick to get it fully "drained". But, after a few minutes, I have a bit of fullness in my dick. I wouldn't call it an erection, but it definitely isn't fully flaccid. I'm guessing there is some blood flow back around the cylinders causing the inflation. I tried after fully deflating pressing the pump slightly to lock the valve in the fill position. Same result, I get some inflation, so I know it isn't any backflow from the reservoir. I don't find it a problem, but it definitely has left me a shower.

Irish Lad 34, I don't think a small amount of inflation is a problem, but as LetoMan said, good question for your doctor.

All the best to you going forward with your Bionic tool.

Most likely your getting feed back from that portion of your implant past where you can squeeze it! You can only squeeze from tip to base of shaft. There’s usually 3-5cms of implant still full of fluid that settles back evenly when your done deflating.

Rider1400, I hadn't thought about the fluid trapped in the cylinder from the base of the shaft back into the body. That would explain why if I squeeze to deflate while I'm lying down it tends to be smaller, but when I stand up, there is an increase is size within a couple of minutes. I definitely went from a grower to a shower. Regardless, I'm happy!

[equusAz]

Yeah - there is absolutely no problem with being partially inflated. You CAN fully deflate if you want - some people get the uncomfortable dog-ears - especially if you don't have an AMS implant. Even if you DO have the AMS with its more forgiving webbing around the implant, you can leave it partially inflated.

For me, when I deflate, I press and hold the button and let the natural pressure equalize. This is the most comfortable type of deflation - i.e. I still have enough shape for it to be NOT a crumpled crisp packet as the OP said. Also, on the AMS, the valve stays in the deflate position well after deflation - so if you compress yourself or anything (tight pants) it can continue to deflate if needed - so its not like its actually inflated - its just in a partially deflated state (if that makes sense).