trimix to bimix: correct new starting dose?

[carnegie86]

Because of pain, I'm switching from Trimix (30/1/10) to Bimix (30/1). I needed 6 units of Trimix to get a very strong erection for at least a couple of hours (nerve damage from bladder removal is my problem).

Does anyone know how much Bimix I might need to get the same result? I just tried 8 units (a little more than the 6 for Trimix) and my erection was about 4/10. Disappointing!

Does this sound about like what I should expect though? Any idea about how high I might have to go? I always think that maybe I've done the injection wrong and can't trust the result.

I am thinking of increasing dose by 2 units at a time but that could take a while depending on how far I might have to go.

Thanks!

[Phil65]

Wow... I wish! 6 units is next to nothing. I don't even have a diagnosis for my ED, let alone any surgery down there and I use 50 units of TRIPLE P SUPERMIX with 2% LIDOCAINE
Papaverine 30mg/ml - Phentalomine 2mg/ml - PGE1 50mcg/ml. That's right, 5x your Trimix PGE mcg's and also 8x the volume injected!

Lots of room to grow, so to speak. LOL

[GoodWood]

You are in the right track. You know your body better than anyone else. Going up by 2 units is a 25% increase and that seems reasonable.

Take your time. And enjoy the experiments.

[frwmw1]

As suggested, your dosage is low. I'm using a bimix that has atropine in it as well, this can increase efficiency.

[carnegie86]

Thanks everybody for your helpful posts. Just wanted to check back in with my results:

It turns out that, after switching from 6 units of Trimix, about 18 units of Bimix gets me hard (9/10) and lasts a couple of hours. I am not nearly as hard / long as I was with the Bimix, but my wife says it is actually more comfortable for her. So all good...

Thanks again.

[wolfpacker]

Keep in mind that Papaverine is known to scar the penis, and you are now injecting a much higher amount of Papaverine than before. Pay attention if you start to notice changes like scar/placque developing