Plunger won't move
Plunger won't move
What does it mean when you make an injection and the plunger is very hard to move? - Mike
Re: Plunger won't move
It means you have improper needle placement. Try a little deeper. If that doesn't work back out a bit and go shallower. This assuming the plunger was free moving before the injection.
R.R.P 2011 Mayo Jacksonville, Dr. M. Wehle. Not nerve sparing. C in margins. Radiation 2023, V.E.D, Viagra and PGE-1 (80mcg/ml) injections @ 8 - 14 units. Originally Edex20, then compounded PGE due to cost. Inject. 12 yrs. It works. Treasure coast of FL.
Re: Plunger won't move
bldoink wrote:It means you have improper needle placement. Try a little deeper. If that doesn't work back out a bit and go shallower. This assuming the plunger was free moving before the injection.
What's stopping the plunger from working? - Mike
Re: Plunger won't move
mhorowit wrote:What's stopping the plunger from working? - Mike
The point of the needle may still be in the tough layers of tissue surrounding the erectile bodies (too shallow), or in the walls of the urethra (too deep) not in the blood-filled erectile bodies themselves where the medication can flow out easily.
Another possibility is that the needle is in a blood clot or tough scar tissue from prior injections.
Never force the injection because that can cause damage.
Re: Plunger won't move
If that plunger doesn't go down super smooth and easy, it is best to remove the needle and pick another spot.
Fifty-one years old. ED started at age forty. I took Cialis for eight years and used Trimix for almost three. Implanted 12/6/22 by Dr. Jonathan Clavell. AMS 700CX 21cm.
-
ftwabeck3533
- Posts: 170
- Joined: Sat Jun 22, 2019 3:21 pm
- Location: South Alabama
- Contact:
Re: Plunger won't move
68CatFan wrote:If that plunger doesn't go down super smooth and easy, it is best to remove the needle and pick another spot.
I would add one step after removing the needle from your cock. Push the plunger and express a minimal amount of trimix from the syringe before re-insertion. I have theorized that pre-loaded frozen syringes will not operate properly on every occasion -- it's unlikely you have a syringe issue, but I believe it is possible.
Born 1955, Erectile Dysfunction, Robotic Prostatectomy (Oct 2018, Dr Bugg @ UCA, Birmingham, AL), PSA<0.007, Trimix User (30 mg Papaverine HCL, 1 mg Phentolamine MES, 10 mcg Alprostadil per 1 ML. My dose is 0.16 ML)
Re: Plunger won't move
ftwabeck3533 wrote:68CatFan wrote:If that plunger doesn't go down super smooth and easy, it is best to remove the needle and pick another spot.
I would add one step after removing the needle from your cock. Push the plunger and express a minimal amount of trimix from the syringe before re-insertion. I have theorized that pre-loaded frozen syringes will not operate properly on every occasion -- it's unlikely you have a syringe issue, but I believe it is possible.
Not a bad idea except that you should be exercising the plunger several times before withdrawing Trimix from the bottle.
Fifty-one years old. ED started at age forty. I took Cialis for eight years and used Trimix for almost three. Implanted 12/6/22 by Dr. Jonathan Clavell. AMS 700CX 21cm.
Re: Plunger won't move
I hate to be contrary but I never find I have to remove the needle. I just adjust the depth in or out. Sometimes I'll also withdraw the plunger a tad just to confirm that it isn't stuck.
R.R.P 2011 Mayo Jacksonville, Dr. M. Wehle. Not nerve sparing. C in margins. Radiation 2023, V.E.D, Viagra and PGE-1 (80mcg/ml) injections @ 8 - 14 units. Originally Edex20, then compounded PGE due to cost. Inject. 12 yrs. It works. Treasure coast of FL.
Who is online
Users browsing this forum: KOJAK8! and 34 guests
