niarceel wrote:The FDA approved the use of PT141 for post-menopausal women a few years ago. Based on my experiments, age nor gender matters. (But my comment is totally subjective based upon the experiences my wife and I have had.)
I have a penile implant and PT141 causes my penis to engorge like a fat sausage, get dark red, just the way I like it, and it feels incredible. And that's before I pump up the implant.
My wife becomes a self-described "nympho" on PT141. She can't get enough penetration from me, and even the slightest touch by me on her clitoris feels like "electricity" to her. She wishes her clitoris could feel like it does on PT141, all the time.
We inject PT141 subcutaneously twice per week. The longer the intervals between injections (days), the better the results.
We get our PT141 from
Peptide Pros. They have always delivered a sterile, potent product to us at a good price.
https://www.peptidepros.net/product/pt-141/I worked these numbers out carefully:1. One purchased vial containing exactly
10 mg of sterile PT141 powder.
2.
Reconstitute (add water): Inject exactly
3 ml of bacteriostatic water into the vial. (Do this slowly to prevent damage to the PT141 compound.)
3. The reconstituted solution created from the previous step produces this ratio:
0.33 mg of PT141 per 10 tics on an insulin syringe. This has to be a syringe with markings of
1 cc/1 ml.
Required:1. You'll need to obtain
sterile reconstitution syringes that will hold a least 3 ml of bacteriostatic water.
2. You'll need some
sterile insulin syringes. I recommend the
Easy Touch brand, 31 gauge (tiny needle),
1 cc/1 ml syringe, 6-8mm long needles. For my numbers to work for you, you must use an injection syringe which has tics on it that are
1 cc/1 ml. This is
VERY important. Otherwise, my numbers are useless.
3. Sterile alcohol pads for injections.
How much to inject? Start slowly and work up to a dose that works for the recipient: I say this because PT141 has had some undesirable side effects for my wife and me, and you want to see how you react to it. (My wife will tell you that the sexual high PT141 produces is worth all the side effects she has.)
I'll give you some working numbers, but you must work up to optimum doses on your own:1. Start with 40 tics. That's 1.33 mg of injected PT141. You will probably not feel much, maybe nothing.
2. I weigh about 160 pounds. Through experimentation (40 tics -> 100 tics), I have found that a 60 tic dose works best for me with few side effects.
3. My wife weighs about 112 pounds. Through experimentation (40 tics -> 100 tics), she has found that a 72 tics dose works best for her with some side effects.
4. Allow 4-5 hours for PT141 to reach maximum effect.
5. Allow 16-18 hours for the PT141 effects to start tapering off. They may last for more than 2 days.
Side effects: 1. Me - I sometimes get low level nausea or just don't feel great until we start having foreplay. Then, those side effects disappear.
2. My wife - She usually has a "fathead" feeling (similar to a Viagra fathead), food aversion, doesn't feel great, and has a coughing, sneezing, runny nose fit for about 5 minutes, a few hours after injection. When we start having foreplay, those side effects disappear.
Techniques: I don't have the time to write them but there are many videos on the internet that will show you safe, sterile, and proper techniques.
1. You'll need to know the
reconstitution technique (adding bacteriostatic water to the PT141 vial).
2. You'll need to know how to use the alcohol prep pads on the tops of vials and your skin.
3. You'll need to know how to safely inject the PT141 solution. (Inject it
shallowly, just underneath your skin on your abdomen. Do not go deep.)
Storage:1. Keep the unreconstituted PT141 powder in a deep freezer. It might last indefinitely.
2. Keep reconstituted PT141 solution in a cold refrigerator, 33F-38F, and it should remain potent for weeks (months?).
Disclaimer:All this being said,
I am not responsible for how you use this information. What I've posted is basic guidelines and information on how my wife and I use PT141. You must perform the techniques/procedures I've described with safety and sterility in mind.
Do not be casual about sterility; your health depends on it. You must perform due diligence to educate yourself before attempting anything. And finally, there is always the possibility that you'll have a bad, possibly dangerous reaction to PT141, especially if you have any underlying health conditions, like heart, blood pressure, liver, kidney, respiratory issues. etc. I am not responsible for anything you do, no matter my intentions to give you good advice. Be fully aware that you may be incurring a health risk by injecting PT141. The decision to inject it is entirely your own, and you assume responsibility for all risks and possible outcomes.
As with all things experimental, proceed with care and caution. Start small, work up slowly and safely. Keep a spreadsheet of your experiments, your observations about your experiences with PT141. We do this and it's helped us see patterns in our responses to it.
I wish you the best possible outcomes.
