First Trimix injection today :-)

[trimix60]

I had my first trimix injection today at my Uro's office, he showed me how to do it and injected .25 cc to start and it did work, not rock hard but better than anything I have been able to get with drugs. It lasted a little more than an hour. He gave me 4 syringes set up with 1.0 cc of trimix in ea. After seeing how .25 cc worked, I am not sure I want to go all the way to 1.0 cc. Does anyone have any suggestions on how to proceed ?? can I take 1 syringe and inject .5, see how that works and then use the same syringe again to use up the trimix ??

Just trying to get a handle on this, thanks for any help you might be able to throw my way.

Happy Holidays to everyone !!!

[Cajun Jeff]

I would not recomend that you jump to 1cc.. that is a good way to make that trip tot he ER for a 4 hr hard!

You can just use 1/2.

Cajun Jeff

[trimix60]

That's what I figured, thanks for the input.

[antelope]

Yes, you can reuse a syringe, although in the future you'd do better to have your own vial and load just what you want and then discard thge syringe. I'm not sure I'd jump to 0.5 ml from 0.25. Maybe go up to 0.3 and see how that works. After all, going from 0.25 ml to 0.3 ml is a 20% increase. If that's not enough, then move up to 0.35 and so on.

Also, be sure to massage up and down the shaft--that will help spread the happy juice and produce the rock-hard erection.
Or you can get someone else to do the massaging. Either way, it's kind of fun.

Just my thoughts.

Best wishes for hard times.

Greg

[trimix60]

Hi Greg- What I got from my Uro today is just getting me started but I guess the price was not really to bad, $10 for a 1.0 cc kit with syringe and everything needed to inject, if I can use it 3 times then that's not to bad I guess. I already figured I would just bump up a little from .25 as you suggest until I find the right dose.

Thanks for the input and advise.

[antelope]

Yep that's a good price. BTW, 1 cc = 1 ml = 100 units. The "unit" is a unit of measure commonly used for insulin injections. You'll hear all three systems used here on the site. Good luck!

[Muz061]

I would put in a dissenting voice here. I wouldn't use the same prepared 1.0ml syringe more than once in my body. Recycling needles is one thing (and I am not prepared to risk that without sterilisation procedures recommended to me) but the same syringe and preparation. I'd rather squirt the excess out, but that's just me.

If 0.25 isn't hard enough for intercourse and lasts an hour I would go to at least 0.35 and maybe 0.4, definitely NOT 0.5ml! Doubling the dose can have a PROFOUND difference in the result. I have had some mixture strength differences and maybe combined with some going off, even in the fridge, that may account for some blips in the response. I have been trending downwards in dose lately and I had the wood last time for 3 hours, real hard and I was starting to get a bit concerned I might have to pop a couple of sudos. Point is I am getting a big response difference between 1.1 and 1.4ml (I must have a dilute trimix) and no way am I going to use 1.4 again while I am trending towards greater sensitivity to the trimix.

However when you are ramping up you need to tread between caution and foolishness. If you trigger a priapism you may put yourself off this therapy for ever. On the other hand if you don't see an increase in results you may lose interest in sticking needles in - you need to see some action. My opinion would be 0.35 as I know you are quite cautious about this process and the worst I think that dose would do (provided you are sure the 0.25 was properly applied) is you could have the hardest erection you have had since you were 20 and would have to live with it for 2-2.5 hours. Stimulation mental and physical also plays a big part in it in my experience, if your wife won't leave it alone you could get errr, overwrought! If you both want to roll over and go to sleep then just let it cool off for a while and it will gradually deflate. It really is a wonder drug when you get the dose right.

Merry Christmas (sorry don't do holidays here!)
Muz

[trimix60]

So I have 4 syringes with 1.0 cc in each, looks like I can get 3 uses out of each one, should I just get replacement needles for reusing the syringe and if so, what size seems to work the best. I will bump up from .25 cc to .33 cc and see first how that works.

Merry Christmas everyone !!!!

Thanks for the help.

[trimix60]

So I have 4 ea 3 cc/ml syringes ea with 1.0 cc/ml of trimix in them. My Uro used a test of .25 and it worked a bit, seems like I will try .33 cc and see how that works and use ea syringe 3 times.

I would like to change out the needle each time, what size seems to be the best ? it says on the current needle it is 27x1/2, is that a 27 gauge 1/2 in long ?? it also says 0.4 mm x 12.7 mm.

Or maybe I should purchase 1 cc syringes for better accuracy with the best needle and fill each one separately.

Where is the best place to purchase supplies ??

A little input from you guy's that have some experience with this would be greatly appreciated.

Thanks for your help !!

[Cajun Jeff]

In Louisiana you can purchase syringes over the counter at any pharmacy. I use 31g needle on a 1cc or .5cc syringe. Hope that helps. Best of luck. I do think that is your best move to load each syrenge.

Cajun Jeff