Looking for a replacement cylinder for my pump

[Cajun Jeff]

The one that came with my pump I think is 2 in. I need one a bit smaller this one keeps trying to suck in a nut. Not fun. Ouch. It’s elect and fits on the top of the tube.

Any help would be appreciated.

[60s_surfer]

I know of two possible solutions that don't require a new cylinder. On the UandMeTime Web site, there is a disk with a hole in the middle that fits over your erection and then the cylinder pushes the flat part of the disk up against your abdomen. You need to lubricate both sides of the disk to get a good seal. The other possibility depends on the exact size of your cylinder. The Timm Medical Web site has an insert that goes inside the cylinder to reduce the inner diameter. I believe it is for a cylinder with 2 inches inside diameter. Timm Medical sells the Osbone pump and constriction rings.

[Cajun Jeff]

Thanks

[dtwarren1942]

If your pump uses a standard male connector, LeLuv offers a decent quality cylinder with a wide base rim for comfort for about $30.

Cylinder sizing according to,LAPump

Girth —---> Cylinder Diameter
3.50 to 4.50* --> 1.50
4.75 to 5.25* --> 1.75
5.50 to 6.00* --> 2.00
6.25 to 6.75* --> 2.25
7.00 to 7.50* --> 2.50
7.75 to 8.25* --> 2.75

[JimStars]

CJ,

The main thing is, ALWAYS be holding onto your nuts when pumping -- stretching scrotum down a bit -- keeping it that way until you slip on the rings. If not using rings and just keeping suction for a while -- well you will just have to judge if they be sucking back into cylinder. With an electric pump it is pretty easy to do pump and hold em with other hand.

J

[Cajun Jeff]

Will try that. What I have done is start with low suction. Get the blood moving. Then add more pressure. After several rounds I can get to full suction. What I am searching far is a cylinder that does not allow girth but pulls for length.

[dtwarren1942]

I have a 2.25” cylinder which I use occasionally, but it does invariably suck in my right Testicle after five minutes or so. I recently carefully slipped on a doubled over 1/2 inch wide elastic band over my balls, Just under the base of my shaft. I used a lot of lube on my balls and the band. And, it prevent my ball from being sucked up.

[Cajun Jeff]

No exactly what you Man about 1/2 inch elastic band. Where do you get that?

[dtwarren1942]

No exactly what you Man about 1/2 inch elastic band. Where do you get that?

1/2 inch is a standard size rubber/elastic band available at stationary section of any big box store or Staples. You can probably get a bag of 100 for about $1.

[Cajun Jeff]

Perfect you guys are so creative. Will pick some up today.